Controls & Features; Deck Height Index; Deck Lift Handle; Ignition Switch - Cub Cadet RZT-S Operator's Manual

Zero-turn tractor
Hide thumbs Also See for RZT-S:
Table of Contents

Advertisement

Available languages

Available languages

Controls & Features
Steering Wheel
Seat Adjustment Lever
Fuel Tank Cap
Transmission Bypass Valves
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that
position on the tractor when facing forward while seated in the
operator's seat.

Deck Height Index

The deck height index consists of eight index notches
located on the front/right of the console. Each notch
corresponds to a 1⁄2" change in the deck height position
ranging from 1-1⁄2" at the lowest notch to 4" at the
highest notch.

Deck Lift Handle

The deck lift handle is located on the front/right of the
console, and is used to raise and lower the mower deck.
Pull the handle to the left out of the index notch and push
downward to lower the deck, or pull upward to raise the
deck. When the desired height is attained, move the lift
handle to the right until fully in the index notch.
Brake Pedal
Forward Drive Pedal
Reverse Drive Pedal
Parking Brake/Cruise Control Lever
Deck Lift Handle
Deck Height Index
Throttle/Choke Control
PTO Knob
Hour Meter/Indicator Panel
Cup Holder

Ignition Switch

Storage Tray
Transmission Bypass Valves
Ignition Switch
The ignition switch is located on the LH console
to the right of the operator's seat. The ignition
switch has three positions as follows:
STOP
— The engine and electrical system is
turned off.
RUN
— The tractor electrical system is energized.
START
— The starter motor will turn over the engine. Release
the key immediately when the engine starts
NOTE: To prevent accidental starting and/or battery discharge,
remove the key from the ignition switch when the tractor is not
in use.
4
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents