Table of Contents
Advertisement
7. ASSEMBLY AND MOUNTING
Read these instructions before starting any assembly or mounting work. Improper
mounting can cause hazards during use of the forest crane. Mounting, carried out in a
manner other than specified in this manual, can expose the user to danger and will void
the manufacturer's warranty.
7.1
Mounting forest crane to Palms trailer
Mounting of forest crane should be performed at the dealer service center or by person
authorized by the manufacturer or dealer. Mounting/detaching the crane can also be
made by end user, if professional equipment is used, all safety regulations are followed
and at least one qualified mechanic is in present during all the mounting/detaching
process.
Strength class for mounting bolts of support legs - trailer (pos. 1, fig. 5) has to be 12.9
(DIN912). Use self-locking nuts M24. Tightening torque for the mounting bolts is 1220
Nm.
Retighten bolts after test run and after first 8 hours of use! Check after 40
working hours, tighten if needed. Later on do visual check.
FOREST TRAILER PALMS 101
Figure 7. Connection junction on A- support legs
Ver 1.00 EN © 2010 Palmse MK
1
10
Advertisement
Table of Contents
