Opel ANTARA 2013 Owner's Manual page 186

184 Vehicle care
4. Before positioning the jack, set it
to the necessary height by
rotating the eye by hand.
Position jack at the jacking point
located nearest to the wheel
concerned so that the jack claw
spans the vertical base. Ensure
the jack is positioned correctly.
The jack base must be on the
ground directly below the jacking
point in a manner that prevents it
from slipping.
5. Attach wheel wrench to eye of
threaded rod and rotate wrench
clockwise to raise vehicle.
If this is not the case, carefully
lower the vehicle immediately and
reposition the jack. Raise the
vehicle until the wheel is just clear
of the ground.
6. Unscrew wheel nuts completely
and wipe clean with a cloth.
Do not grease the threads. Put
wheel nuts somewhere where the
threads will not be soiled.
7. Change the wheel. Notes on
spare wheel 3 185.
8. Screw on the wheel nuts and
tighten slightly by hand by turning
clockwise until wheel is held
against the hub.
9. Rotate wrench anticlockwise and
lower vehicle to the ground.
10. Install the wheel wrench ensuring
that it locates securely and tighten
each wheel nut in a crosswise
sequence. Tightening torque is
140 Nm.
11. Stow the replaced wheel 3 185
and the vehicle tools 3 173.
12. Check the tyre pressure of the
installed tyre as soon as possible.