52”LANGHAM CEILING FAN Owner’s Manual Models #20265, 20266 If a problem cannot be remedied or you are experiencing difficulty in installation, please contact the Service Department: 1-877-459-3267, 9 a.m.- 5 p.m. Central time. Turn of the Century 9049 • 01/10/14...
PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items: PACKAGE CONTENTS 1. Canopy 10. Finial 2. Canopy Cover 11. Downrod 3. Mounting Bracket 12. Adapter Cover 4. Motor Housing 13. Blade Arm (x 5) 5.
DIMENSION REFERENCE A. 18.90 in. B. 12.20 in. C. 2.40 in. D. 11.18 in. E. 5.08 in. MOUNTING OPTIONS Triple Mount Drawing Closemount Downrod Mount Slope Ceiling Mount (Up to 23 degrees) Choose one of the following mounting options: Closemount method is best suited for ceilings lower than 8 feet. It does not utilize the downrod. Downrod Mount is best suited for ceilings 8 ft.
SAFETY INSTRUCTIONS READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLING THE FAN AND SAVE INSTRUCTIONS. All set screws of the fan must be checked and retightened where necessary before installation. To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning fan.
Page 5
ASSEMBLY INSTRUCTIONS 1. Turn OFF the electrical power at the main fuse or circuit breaker. 2. Remove the canopy from the mounting bracket Mounting by removing the two mounting bracket screws from Bracket Screw the round holes in the canopy. Then loosen the other two mounting bracket screws from the L-shaped slots.
Page 6
ASSEMBLY INSTRUCTIONS 5. Loosen but don’t remove the set screws in the motor Motor Adapter adapter. Then remove the downrod pin and downrod clip from the downrod. Downrod Downrod Clip 6. Feed the wires coming from the motor adapter through the adapter cover, canopy and downrod. Downrod Canopy Adapter Cover...
Page 7
ASSEMBLY INSTRUCTIONS 9. Use wire connectors to connect the fan wires to the power supply wires according to the wiring diagram and Black the following instructions: White • Connect the white wire from the fan to the white (neutral/ Bare/Green common) supply wire.
Page 8
ASSEMBLY INSTRUCTIONS 13. Remove the three switch housing screws from the bottom edge of the switch housing. Connect the single- pin connectors from the fan to the single-pin connectors Single-pin from the light kit -- black to blue and white to white. Switch Connector Housing...
Page 9
ASSEMBLY INSTRUCTIONS 17. Restore the power at the main fuse or circuit breaker. 18. NO LIGHT KIT OPTION (OPTIONAL) a. Remove the three switch housing screws from the lower edge switch housing. b. Remove the light kit from the switch housing cap by removing the hex nut and washer from inside the switch housing cap.
Page 10
OPERATING INSTRUCTIONS 1. The fan pull chain is located in the off-center hole in the finial cap. It has four positions to control fan speed. One pull is HIGH, two is MEDIUM, three is LOW and four turns the fan OFF. The light pull chain is located in the center of the finial.
TROUBLESHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check the Troubleshooting section below. If a problem cannot be remedied or you are experiencing difficulty in installation, please contact the Service Department: 1-877-459-3267, 9 a.m.- 5 p.m.
1-877-459-3267, 9 a.m.- 5 p.m. central time. Model Name: 52” Langham Ceiling Fan Model No: 20265 - Oil Rubbed Bronze (SKU: 355-7050) 20266 - Brushed Nickel (SKU:355-7051) The limited lifetime warranty covers this ceiling fan, for residential use by the original purchaser, against...
Need help?
Do you have a question about the 20265 and is the answer not in the manual?
Questions and answers