Sony Playstation Portable PSP Safety And Support page 9

• Put both the PSP system and the Remote Control in Hold Mode to
®
help prevent unintended operation.
Never disassemble the system or
accessories
Use the PSP system and accessories according to the instructions in this
®
manual. No authorisation for the analysis or modification of the system,
or the analysis and use of its circuit configurations, is provided.
Disassembling will void the system warranty and may be harmful. The
LCD screen, in particular, contains dangerous, high-voltage parts, and
the laser beam for reading UMD™ may cause visual impairment if
exposed directly to the eyes.
Using the access point
When using the PSP system's 'Scan' function to select a wireless LAN
®
access point, access points that are not intended for public use may be
displayed. Only connect to a personal access point that you are
authorised to use, or one that is available through a public wireless
LAN or hotspot service.
Overseas use
When travelling note any applicable wireless regulations.
Moisture condensation
If the PSP system or UMD™ is brought directly from a cold location
®
to a warm one, moisture may condense on the lens inside the system or
on the UMD™. Should this occur, the system may not operate
properly. In this case, remove the UMD™ and turn off and unplug the
system. Do not put the UMD™ back in until the moisture evaporates
(this may take several hours). If the system still does not operate
properly, contact the appropriate PSP
which can be found within every PSP
UMD™ handling
• Do not touch the opening on the rear of the disc (recorded surface of
the disc) with your fingers.
• Do not allow dust, sand, foreign objects or other types of dirt to get
on the disc.
• If the UMD™ becomes dirty, gently wipe the exterior and recorded
surfaces of the UMD™ using a soft cloth. Do not use solvents or
other chemicals.
• Do not use a UMD™ that is cracked or warped or has been repaired.
The UMD™ may break inside the PSP
malfunction.
Handling and care of exterior surfaces
Follow the guidelines listed below to help avoid deterioration or
discoloration of the PSP system:
®
• Do not use solvents or other chemicals to clean the exterior surface.
• Do not allow the system to remain in direct contact with rubber or
vinyl products for an extended period of time.
• Do not use a chemically-treated cleaning cloth to wipe off the
system.
customer service helpline
®
format software manual.
®
system, leading to injury or
®
Precautions
9