Linksys Instant Wireless Series User Manual page 13

• SSID - Displays the wireless network's current SSID. If it displays "non-
spec," then the Bridge is not connected to any wireless network.
• Channel - Displays the Bridge's current channel number.
• BSSID - Displays the wireless network's current BSSID. For infrastructure
mode, the BSSID is the MAC address of the access point to which the
Bridge is connected.
• Transmission Rate - Displays the transmission rate of the current connec-
tion.
• Link Quality (%) - When the Bridge is connected to a wired LAN, the per-
centage of connection integrity is displayed. (This is not available when
using an ad-hoc or peer-to-peer connection.)
• MAC Address - Displays the Bridge's MAC address.
• IP Address - Displays the Bridge's IP address.
• Firmware Revision - Displays the version number of the Bridge's
firmware.
The "Results of the most recent scan" section displays information about all
devices detected by the Bridge.
• SSID - Displays the current SSID of a network device.
• MAC Address - Displays the wireless MAC address of a network device.
• Channel - Displays the current channel number of a network device.
• Signal Strength (%) - Displays the total available amount of signal meas-
ured above the noise. (This is not available when using an ad-hoc or peer-
to-peer connection.)
• Mode - Displays the operating mode of a network device.
Note: You may have to refresh this page to see any new settings.
20
Instant Wireless Series
TM
Wireless Ethernet Bridge
WIRELESS
The Wireless screen allows you to configure your wireless settings. Any new
settings will not take effect until the Bridge is rebooted. (To reboot the Bridge,
click the Admin tab, and click the Reboot button.)
Figure 6-4
21