Table of Contents
Advertisement
-[no]daemon
-[no]debug
-noreload
-packfreq interval{s|m|h}
-procfreq interval{s|m|h}
-server s
-start
-stop
-u
-v
-verbose v
Installation
The amgrd command can be installed from a depot available on the HP VSE Managed Node
Software Update Web site. For installation instructions, please visit the VSE Management Web
site at the following URL:
http://docs.hp.com/en/vsemgmt/agents.html
Beginning with VSE Management Software Version A.03.00.00, amgrd is installed on the CMS
when the VSE Management Software is installed.
RETURN VALUES
0
The command completed successfully; no errors were detected.
1
An error occurred, and the command did not complete successfully.
EXAMPLES
Start HP Application Discovery Agent as a daemon, and allow it to run with default options
picked from the file /var/opt/amgr/agent.properties:
# /opt/amgr/bin/amgrd
<timestamp> Starting agent...
Check the connection status of HP Application Discovery agent:
# /opt/amgr/bin/amgrd -connectionstatus
OK
[Do not] run the agent as a daemon. -daemon is the default
setting for amgrd. Use -nodaemon only for triage as the
agent will die if the terminal session ends or the terminal
is disconnected.
[Do not] run the agent in debug mode.
Do not read in persisted data (used when agent is started
or restarted).
Set the package catalog collection frequency to a number
t, with s for seconds, m for minutes, or h for hours.
Set the process collection frequency to a number t, with s
for seconds, m for minutes, or h for hours.
Connect to, try to connect to, or only communicate with
the Application Discovery server on machine s, where s is
the address of a machine running a central management
server.
Start an agent and read in persisted data. This option is
needed explicitly to enable the setting of restart and starting
or restarting on the same invocation.
Stop a running agent.
(usage) Show current usage information and exit.
(version) Show current HP Application Discovery version
and exit.
Set log verbose to v, which can have the following values:
0 = Disable log
1= LOG_FATAL
2 = LOG_ERROR
3 = LOG_WARN
4 = LOG_ALWAYS
5 = LOG_NOTE (default)
6 = LOG_TRACE
57
Advertisement
Table of Contents
