Cisco CATALYST RPS 2300 Installation Notes page 7

Figure 5
Align the two captive screws with the screw holes in the panel. Using a ratcheting torque screwdriver,
Step 7
torque each screw to 10 lbf-in. (160 ozf-in.).
Connect the power cord to the power supply and to an AC-power outlet.
Step 8
(Optional) Snap the AC power cord retainer into place to secure the power cord
Step 9
Figure 6
Figure 7
R ed un da
nt Po w er
5
6
S TD B Y /
A C TI V E
Turn on the power at the power source.
Step 10
Confirm that the power supply AC OK LED is green. See
Step 11
78-17570-01
Inserting an AC-Power Supply into an RPS 2300
100- 240
V
10-5 A AC OK
DC OK
50-6 0 HZ
100- 240
V
10-5 A
Ci sc o RP
50-6 0 HZ STD BY
/ DC OU TP
AC TIV E
1 UT
2
3
TEM P
4
5
FAN 6
SE LE CT
ST DB Y/
AC TIV E
100- 240
V
10-5 A
AC OK
50-6 0 HZ DC OK
AC-Power Supply and Power Cord Retainer Installed in a Switch
10 0-2 40
V
10 -5 A
AC OK
50 -60 HZ
PS OK
AC-Power Supply and Power Cord Retainer Installed in the RPS 2300
Sy st em 23
00
100 -24 0
V
10- 5 A
AC OK
50- 60 HZ
Installation Notes for Catalyst 3750-E, Catalyst 3560-E Switches and RPS 2300 Power Supply Modules
S 24 50
100- 240
V
10-5 A
50-6 0 HZ
DC OK
Table 3
Power Supply Module Installation
(Figure 6 and
for a description of the module LEDs.
Figure 7).
7