Setting Time And Day; Programming Guide; Programming Your Thermostat - Robertshaw 8600 User Manual

Programming Guide

heat off cool
MON
run/set temp
prog hold
select
SETTING TIME OF DAY AND
DAY OF WEEK
1. Press SELECT until the cursor is
over SET CLOCK. Press SET. The
HOURS segment will be blinking.
Use the
the hours setting. NOTE: The AM
or PM indicator will change as the
HOURS display rolls through a 24
hour cycle.
2. Press SET. The MINUTES segment will be blinking. Use the
button to adjust the MINUTES setting.
3. Press SET. The DAY segment will be blinking at the top of the display.
Use the

PROGRAMMING YOUR THERMOSTAT

The 8600 thermostat features 1-button programming. Simply follow these
steps to customize your thermostat for your lifestyle.
1. Place the HEAT-OFF-COOL switch into the HEAT position. Make sure
the cursor is in the RUN/SET PROG position. Press SET. The HOURS
segment will be blinking. MON thru FRI
(the work week) will be displayed across
the top. AM1 will be illuminated in the
lower right hand corner. You can now
start programming the first event of the
work week.
2. Use the
Press SET.
3. The MINUTES segment will be blinking. Use the
adjust the minutes. Press SET.
4. The temperature should be blinking. Use the
adjust the desired temperature of the first event. Press SET.
5. AM2 should now be displayed. Repeat
steps 2-4 to program the remaining events
(PM1 and PM2) for the work week. There
are a total of 4 events.
auto on
° F
vac set
hold clock
set
or button to adjust
or button to adjust the day of the week. Press SET.
or button to adjust the hour of the first event.
o on
Cursor
temp vac
run/set
prog hold hold
select
MON = MONDAY
TUE = TUESDAY
WED = WEDNESDAY
THU = THURSDAY
FRI = FRIDAY
SAT = SATURDAY
SUN = SUNDAY
8
set
clock
set
or button to
or button to
or