Virtual Servers List - D-Link DIR-615 User Manual

Section 3 - Coniguration
This will allow you to open a single port for access by specified clients. If you have multiple clients on your network that require
an open port, you will need to create a Virtual Server rule for each client.
Name:
Enter a name for the rule or select an application from the drop-down
menu. Select an application and click << to populate the fields.
IP Address:
Enter the IP address of the computer on your local network that you
want to allow the incoming service to. If your computer is receiving an
IP address automatically from the router (DHCP), you computer will be
listed in the Computer Name drop-down menu. Select your computer
and click <<.
Private Port/
Enter the port that you want to open next to Private Port and Public Port.
Public Port:
The private and public ports are usually the same. The public port is the
port seen from the Internet side, and the private port is the port being
used by the application on the computer within your local network.
Protocol Type:
Select TCP, UDP, Both or Other from the drop-down menu.
Inbound Filter:
Select Allow All (most common) or a created inbound filter. You may
create your own inbound filters in the Advanced > Inbound Filter page.
Schedule:
The schedule of time when the virtual server rule will be enabled. The
schedule may be set to Always, which will allow the particular service
to always be enabled. You can create your own times in the Tools >
Schedules section.
D-Link DIR-615 User Manual

Virtual Servers List

29