Advertisement
Quick Links
Advertisement
Summary of Contents for Polaris WaterStar
- Page 1 I M P O R T A N T I N F O R M A T I O N...
-
Page 2: Exploded Parts Diagram
Adjustable Plug, UWF 6-502-00 Quick Disconnect, UWF 6-505-00 O-ring, UWF/QD 6-500-00 Universal Wall Fitting (UWF) To ensure proper operation and long life for the 7-295-00 UWF Connector Assembly Polaris, be sure to insist on genuine Polaris parts. 11-103-00 Restrictor Washer... -
Page 3: Installation Instructions
I. Introduction • If the return line for the Polaris looks like the one below, remove the parts shown and install Your new Polaris WaterStars will create a the universal wall fitting as described above. beautiful fountain from the pressure of a typical filtration pump. - Page 4 WaterStars while tightening the plug will increase it. from the pool wall. If you have a Polaris 380, 280, or 180 and have Collapse the hose inside the quick too much water pressure, you will need to install disconnect with your fingers and pull off the the restrictor washer included with the fountain.
- Page 5 Leave the universal wall fitting attached to the quick disconnect during storage. In some cases, it may be necessary to use the universal wall fitting removal tool (part #10- 00), available from your participating Polaris dealer.
- Page 6 3. The WaterStars owner may send parts presumed defective directly to Polaris Pool Sys tems, Inc., freight prepaid. Polaris agrees that the products are defective and covered by this warranty, Polaris will repair or replace, at its option, and return the parts freight pre-paid, with no charge for repairs.
- Page 7 ©2002 Polaris Pools Systems, Inc. All Rights Reserved. 7-1-0609 7/02...