Download Print this page

Hotpoint FFQ48 Instructions For Installation And Use Manual page 5

Hotpoint model ffq48 refrigerator/freezer instructions for installation and use

Advertisement

Disposing of the plug
Cut off and dispose of the supplied plug if it does not fit
your socket. The cable should be cut as close as
possible to the moulded plug.
Remove the fuse.
WARNING:
To avoid a shock hazard do not insert the discarded
plug into a socket anywhere else.
Fitting a new plug
IMPORTANT
:
WIRES IN THE MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE...
Green and Yellow - Earth
Blue
- Neutral
Brown
- Live
As the colours of the wires in the mains lead may not
correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
-
Connect Green and Yellow wire to terminal marked
'E' or
or coloured Green and Yellow.
-
Connect Brown wire to terminal marked 'L' or
coloured red or brown.
-
Connect Blue wire to terminal marked 'N' or
coloured Black or Blue.
If a 13amp plug (BS 1363) is used it must be
fitted with a 13amp fuse. A 15amp plug must be
protected by a 15amp fuse, either in the plug or adaptor
or at the distribution board.
If you are in any doubt about the electrical
supply to your machine, consult a qualified
electrician before use.
CE Marking certifies that this appliance conforms to
the following EEC directives :
Low Voltage Equipment - 73/23/EEC & 93/68 EEC
Electromagnetic Compatibility 89/336/EEC, 92/31/EEC
& 93/68/EEC
The refrigerator you have purchased is fitted with the
Aqua Care system which, thanks to an advanced filter
system with active carbons, provides your household
with fresh, filtered water.
! To improve the system's performance, we recommend
that you follow the instructions contained in this manual
and in the assembly diagram provided with the kit.
After connecting it to the water system, installing the
filter (see Replacing Aqua Care filter) and switching on
the refrigerator (See Starting the appliance), it is
necessary to remove any air from the Aqua Care system:
1. Activate the AQUA CARE
function by pressing the correct
button (see Display)
2. Place a container under the
dispenser.
3. Hold the button down until the
water is dispensed.
4. Drain and discard three litres
of water.
! When using for the first time and each time the Aqua
Care system is not used for more than 1 week, it will be
necessary to drain and discard three litres of water.
GB

Advertisement

loading