Human Touch PC6 Use & Care Manual page 5

take a seat
Adjust the recline angle
To recline, gently pull up on the recline lever, lean back on the backrest to adjust it to the desired angle, then
release the lever. To incline to a more upright position, gently pull up on the recline lever, then pull up on
the armrests with your hands while applying slight downward pressure with your elbows, until the backrest
inclines to the desired position. Release the recline lever.
NOTE: Lean back against the backrest before reclining the chair.
CAUTION: Do not put any extra pressure on the footrest while reclining the chair.
Do not push on the footrest, or lean against it.
Adjust the headrest
While seated, reach up with both hands and grasp both sides of
the headrest. You will feel the rigid frame beneath the soft head
pad. Grasping the rigid frame, tilt the headrest forward or back-
ward for maximum comfort. The headrest remains in this position
until you adjust it again.
When adjusting the footrest up and down, you may notice a slight bumping sensation.
This is caused by the footrest locking mechanism, and is perfectly normal.
humantouch.com
6
Using your Human Touch Perfect Chair
adjust the chair to the desired position. The Perfect Chair cradles you
in zero-gravity comfort, with your feet above your heart—the ultimate
neutral-posture position for back and spine relief.
Getting out of the perfect chair
Gently pull up on the recline lever, pull up on the armrests with
your hands while applying slight downward pressure with your
elbows, until the backrest inclines to a full upright position.
Release the recline lever. Use the arms for support when getting
up from the chair.
CAUTION: Do not put any extra pressure on the footrest
while returning the chair to an upright position. Do not
push on the footrest, or lean against it.
Adjusting body pad thickness
1. To compress the body pad thickness, sit in the chair, lean
against the backrest, then push the ball valve on the back of
the body pad. When the pad reaches the desired thickness,
release the valve.
2. To reinflate the body pad, push the ball valve without
applying any pressure to the pad. When the
pad reaches the desired thickness, release the
valve. It takes approximately ten seconds for the
pad to reach its full thickness.
NOTE: If your pad set comes with a separate lumbar pillow instead of built-in lumbar support in the body pad, apply these
instructions to the lumbar pillow to inflate or deflate it as desired.
bODY PAD PERFORMANCE NOTES
• You must remove all body weight from the pad when reinflating it.
• If the pad has been compressed for a long period of time, it may take up to one minute to restore it to its full thickness.
• The colder the pad is, the longer it takes to react to form changes.
• Should the ball valve leak, push the black ball in and, with a cotton swab, apply a small amount of Vaseline inside the valve.
• Keep sharp objects away from the pad. The pad contains a precision air-tight bladder which that will not function properly
if punctured.
is easy. Just take a seat and
Body pad
7