Related Manuals for Philips MCM2320/12
Summary of Contents for Philips MCM2320/12
- Page 1 Always there to help you Register your product and get support at www.philips.com/welcome Question? Contact Philips User manual...
-
Page 3: Table Of Contents
Contents 7 Other features Set the alarm timer Set the sleep timer 1 Important Listen to an external device Safety Notice 8 Product information 2 Your Micro Music System USB playability information Introduction Supported MP3 disc formats What's in the box Overview of the main unit 9 Troubleshooting Overview of the remote control... -
Page 4: Important
1 Important Never expose the remote control or batteries to rain, water, sunshine, or excessive heat. Avoid force coming onto power plugs. Correctly install the battery with its Safety polarity (+/- signs) as marked on the remote control. Danger of explosion if battery is incorrectly Read and understand all instructions before replaced. -
Page 5: Care Of The Environment
Your product contains batteries covered by Compliance the European Directive 2006/66/EC, which cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent This product complies with the radio negative consequences for the environmental interference requirements of the European and human health. -
Page 6: Your Micro Music System
2 Your Micro Music System Congratulations on your purchase, and support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can: enjoy audio from discs, USB devices, and other external devices; listen to radio stations. You can enrich sound output with below... -
Page 7: Overview Of The Main Unit
Overview of the main unit Start or pause play. Turn on the product. Switch to standby mode or ECO Stop play. power standby mode. Erase a program. b Display panel Show current status. Connect USB storage devices. d AUDIO IN Connect external audio devices. -
Page 8: Overview Of The Remote Control
f VOL +/- Overview of the remote Adjust volume. control g MUTE Mute or restore volume. h SOUND Enrich sound effect with Digital Sound Control (DSC). i CLOCK AUDIO IN Set the clock. PRESET/ALBUM View clock information. j SLEEP/TIMER Set sleep timer. Set alarm timer. -
Page 9: Get Started
3 Get started Caution Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Connect speakers Note Connect power Insert the stripped portion of each speaker wire into the socket completely. -
Page 10: Prepare The Remote Control
Prepare the remote control Note MCM2320 switches to Standby mode after 15 minutes Caution inactive. Risk of product damage! When the remote control is not used for long periods, remove the batteries. Switch to ECO power standby mode To insert the remote control battery: Press and hold for more than two seconds. -
Page 11: Select A Source
4 Play Note To view clock information in working mode, press CLOCK. If no button is pressed in 90 seconds during setting, MCM2320 exits clock setting without saving earlier operations. Play from disc Press CD to select CD source. Select a source Press to open the disc compartment. -
Page 12: Play From Usb
VOL +/- Increase or decrease the volume. Play from USB MUTE Mute or restore sound. SOUND Select a preset sound equalizer. Note DISPLAY Adjust display brightness. Make sure that the USB device contains playable audio content. Skip tracks Insert a USB device into the socket. -
Page 13: Listen To The Radio
5 Listen to the Program radio stations radio manually Tune to a radio station. Tune to a radio station Press PROG, and then press select a number from 1–20. Press PROG » The preset number and the frequency Position the antenna as far as possible from TV, VCR, or of the preset station are displayed. -
Page 14: Adjust Sound
6 Adjust sound 7 Other features The following operations are applicable to all supported media. Set the alarm timer Select a preset sound effect This product can be used as an alarm clock. You Press SOUND repeatedly to select a storage device as alarm source. -
Page 15: Set The Sleep Timer
Listen to an external device Note If you do not stop an alarm, it keeps ringing for 30 minutes, and then the product automatically switches to You can listen to an external device through this normal standby mode. unit with an MP3 link cable. Connect an MP3 link cable (not supplied) between: Activate/deactivate alarm timer... -
Page 16: Product Information
8 Product information USB Direct Version 2.0 full speed USB 5 V Power Note Disc Product information is subject to change without prior Laser Type Semiconductor notice. Disc Diameter 12 cm/8 cm Support Disc CD-DA, CD-R, CD- RW, MP3-CD Audio DAC 24 Bits/44.1 kHz Total Harmonic <1% (1 kHz) -
Page 17: Usb Playability Information
MP3 bit rate (data rate): 32-320 Kbps and requesting service. If the problem remains variable bit rate unsolved, go to the Philips Web page (www. Directory nesting up to a maximum of 8 philips.com/support). When you contact Philips, levels... - Page 18 Remote control does not work select the correct source with the remote control instead of the main unit. Reduce the distance between the remote control and the unit. Insert the battery with its polarities (+/– signs) aligned as indicated. Replace the battery. Aim the remote control directly at the sensor on the front of the unit.
- Page 20 Specifications are subject to change without notice. 2014 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V. MCM2320_12_UM_V1.0...