ImageLab FS-5T12 User Manual page 11

USING YOUR SCANNER
Setting Up Your Scanner
1. Connect the Power Adapter
Make sure the 4-way switch is set to OFF. Locate the Power Adapter port on
the back of the scanner. Connect the Power Adapter to the scanner first before
connecting the Power Adapter to the electrical wall socket.
Optional -- Insert 3 AAA Alkaline Batteries (Not Included)
Turn the scanner upside down. Take the battery cover off the scanner. Insert
the batteries aligning them with the + and – symbols. Replace the battery
cover. When batteries are used, the scanner will operate without the Power
Adapter. The batteries do not need to be removed, if you are using the Power
Adapter.
Optional -- Insert Your SD Memory Card (Not Included)
To scan your pictures to an SD Memory Card, insert your SD card label-side up
into the SD slot located on the right side of the camera. Push the SD card into
the scanner until you hear or feel a click. The scanner is compatible with SD
cards with a capacity up to 2GB. If an SD card is not inserted, the scanner will
record to its internal memory (about 20 pictures).
10