How To Use; Control Panel Features - Kenmore 796.3152#21 Use & Care Manual

WARNING:
To reduce the risk of fire, electric shock, or injury to persons, read and follow this
entire Use & Care Guide, including the Important Safety Instructions, before operating this washer.

CONTROL PANEL FEATURES

E
A
A POWER (ON/OFF) BUTTON
Press to turn the washer ON. Press again to turn
the washer OFF. Pressing the POWER button
during a cycle will cancel that cycle and any
load settings will be lost. The lid will unlock after
a brief pause.
NOTE: If the washer remains idle for four
minutes after turning the washer off, any water
left in the tub will automatically be drained. An
alarm will sound one minute prior to draining,
and 'dr' will appear on the display. You may
restart the washer at this time. However, once
the washer initiates draining, all functions will
be suspended and cycle settings lost, and 'dr'
will be displayed until draining is complete.
B
CYCLE SELECTOR KNOB
Turn this knob to select the desired cycle. Once the
desired cycle has been selected, the standard presets
will appear in the display. These settings can be
adjusted using the cycle setting buttons anytime
before starting the cycle.
NOTE: To protect your clothing, not all settings are available on all cycle selections.

HOW TO USE

B
C
START/PAUSE BUTTON
Press this button to start the selected cycle.
If the washer is running, use this button to pause
the cycle without losing the current settings.
NOTE: If you do not press the START/PAUSE
button within four minutes of selecting a cycle,
the washer automatically turns OFF. If the
washer is paused during a cycle for more than
four minutes, the cycle will be cancelled and
any water remaining in the tub will be drained.
An alarm will sound at three minutes to warn
you that the tub is about to drain.
D CYCLE MODIFIER BUTTONS
Use these buttons to adjust the settings for the
selected cycle. The settings light up above the
buttons to show the current selection.
E
SPECIAL CYCLE AND OPTION BUTTONS
These buttons allow your to select special cycles
or options.
F TIME AND STATUS DISPLAY
The display shows the cycle status and estimated
time remaining.
12
F
C
D