Batteries; Cleaning - Philips 55PFS8159 User Manual

To pair a new — not yet paired — TV with a remote control
which is already paired with another TV, hold the remote
control close to the Philips logo (about 10cm) and press the
 Red and  Blue key at the same time. A message will
appear if pairing is successful.
Note:
If the remote control is still fail to pair the TV, press  > Setup
> TV settings > General settings > Reinstall TV, then repeat
pairing step again.
6.7

Batteries

With sliding door
If the TV does not react on a key press on the remote control,
the batteries might be empty.
To replace the batteries, open the battery compartement on the
keyboard side of the remote control.
1. Slide the battery door in the direction shown by the
arrow.
2. Replace the old batteries with 2 type AAA-LR03-1.5V
alkaline batteries. Make sure the + and the - ends of the
batteries line up correctly.
3. Reposition the battery door and slide it back until it
clicks.
Remove the batteries if you are not using the remote control for
a long time.
Safely dispose of your old batteries according to the end of use
directions.
For more information, press
use.
With click door
The TV will notify you when the battery power of the remote
control is low.
To replace the batteries, open the battery compartement on the
keyboard side of the remote control.
1. Use a small coin or other small, blunt object and press
the square shaped release button to open the battery lid.
 Keywords and look up End of
2. Slide the blue lock open in the direction shown by the
arrow and lift the lock.
3. Replace the old batteries with 2
type AA-LR6-1.5V alkaline batteries. Make sure the +
and the - ends of the batteries line up correctly.
4. Push the blue lock down and slide it back until it clicks.
5. Reposition the battery door and push it down until it
clicks.
Put the remote control down for about 15 seconds to calibrate
the pointer.
Remove the batteries if you are not using the remote control for
a long time.
Safely dispose of your old batteries according to the end of use
directions.
For more information, press
use.
6.8

Cleaning

Your remote control is treated with a scratch-resistant coating.
To clean the remote control, use a soft damp cloth. Never use
substances such as alcohol, chemicals or household cleaners on
the remote control.
26
 Keywords and look up End of