Dixon ZTR 5423 Operator's Manual page 12

CHASSIS:
BODY:
SEAT:
MOWER DECK:
BLADE DRIVE:
DRIVE SYSTEM:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:
SPECIFICATIONS
Model ZTR 5502
1 1 GA - rectangular tube
Two piece - made of rotational molded polyethylene. Front body contains
access panels for battery service and engine to mower deck belt removal. Rear
body tilts up to allow service on the entire drive system.
Economically designed for operator comfort by use of high density closed cell
foam, contoured back rest and arm rests. Seat is adjustable fore and aft.
1 1 GA fabricated welded construction with external reinforcement ribs 3
blades combine for a 50" cut width Cut height approximately 1 .5" to
4.5" via 8 position lift handle
Electric clutch
Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
enclosed HydroGear gearbox.
20HPKohler Command, 4-Cycle,V-Configuration, Overhead Valve, Air-Cooled,
Gasoline, Horizontal and Vertical Shaft, Aluminum Head, and Crankcase with
Cast Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-type Fuel
Pump, Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition, In-Line Fuel
Filter, Dual Element" Air Cleaner.
Electric by key switch operation with safety interlocks on parking brake and blade
drive clutch.
Front 1 1 X 4 X 5 smooth profile
Rear 20 X 10 X8 Multi Trac
Front 16-21 Ibs.
Rear 8 -14 Ibs.
Fuel - 4.8 gallons total (dual tanks) Hydrostat oil tank -
3 quart with in-line 10 micron filter Hydrostat oil
recommendation, refer to page 37 Engine - 2 qts. SAE
1 0W30 (with filter)
Width 60"
Height 45"
Length 72"
Weight 680 Ibs.
Additional information provided in service instructions underthe individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Page 9