External I/O Interface - Plustek Network Camera User Manual

Information

External I/O Interface

The external I/O interface provides a solution to integrate the network camera with external
sensor or device as an EventTrigger. Connection of an external sensor or device may
activate the alarm feature in the Plustek Network Camera Configuration center. The external
sensor or device is not included in the package; you need to purchase them if you need to
use this function.
What is External I/O Interface?
Pin Function
1 External Sensor Input
External Sensor Input receives the signal that produced by the alarm sensor (e.g.
door sensor, infrared ray sensor). Those signals can activate the GPIO function.
Please refer to EventTrigger section for more settings.
2 GND
3 External Device Control Output
External Device Control Output sends the electric current to activate the external
devices (e.g. light, buzzer). It is an open collector circuit and the maximum drawing-
in current is DC +5V, 100mA. Prevent the maximum voltage from exceeding DC
power Output voltage of Pin 2.
Please consult your network administrator or ISP for the IP number of
your network camera.
42