Bulb Replacement; High Intensity Discharge; (Hid) Lighting; Taillamps, Turn Signal, And Stoplamps - Buick Enclave 2015 Owner's Manual

Bulb Replacement

For the proper type of replacement
bulbs, see Replacement Bulbs on
page 10-28.
For any bulb changing procedure
not listed in this section, contact
your dealer.

High Intensity Discharge

(HID) Lighting

Warning
The high intensity discharge
lighting system operates at a very
high voltage. If you try to service
any of the system components,
you could be seriously injured.
Have your dealer or a qualified
technician service them.
After an HID headlamp bulb has
been replaced, the beam might be a
slightly different shade than it was
originally. This is normal.
Taillamps, Turn Signal,
and Stoplamps
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2-8.
2. Using a small flat bladed tool,
remove the screw covers by
prying them from the bottom.
3. Remove the two hex screws
holding the taillamp assembly in
place.
4. Pull out the taillamp assembly.
Vehicle Care
5. Turn the bulb socket
counterclockwise and pull it
straight out to remove it.
6. Replace the bulb.
7. Reverse Steps 3 5 to reinstall
the taillamp assembly.
When reinstalling the taillamp
assembly, the pin on the taillamp
assembly must line up and be
inserted correctly into the
opening.
8. Replace the screw covers.

License Plate Lamp

To replace one of these bulbs:
1. Remove the two push pins
holding each of the license plate
lamps to the liftgate trim by
unscrewing them.
10-27