Selecting Call Tones; Main Channel Scan - Radio Shack Genex MK 2000 Owner's Manual

Operation

Selecting Call Tones

Your MK 2000 GMRS radio provides 3 user selectable call tones to
alert you of an incoming signal.
To select your favorite call tones,
1. Press the MODE button 7 times and "
screen.
2. Push the Up( §) or Down( ') button to select your favorite call
tone.
3. Press the MODE button once to exit from the Call Tone selection
mode, or simply press the PTT button once.
" will appear on the LCD
Flashing
17
Operation

Main Channel Scan

This feature allows you to monitor all channels automatically for valid
signals. While scanning, you can transmit and receive. When a signal
is received, scan is interrupted and you will hear the channel for 5
seconds. After the 5 seconds, the unit will resume scanning unless
the Scan button is pressed again as described below.
1. To start Scan mode, press the SCAN button momentarily.
The ( ) icon will be displayed on the LCD screen and the unit
will scan through the 15 channels to find an active channel. When
an active channel is found, it will be heard for 5 seconds, and then
scanning will resume.
2. If the unit does not locate an active signal and you would like to
transmit, press the PTT button to return to home channel operation.
After approximately 5 seconds after the communication is complet-
ed, the transceiver will automatically resume scanning.
3. To exit from the Scan mode, press the SCAN button again. The unit
will return to normal operation and the (
from the LCD screen.
) icon will disappear
18