Package Contents - Power Acoustik P-8AMX Specifications

Package Contents

Two speakers, mixer, panel, power cord, two speaker cables, Owner's Manual (this booklet)
NOTE: The mixer and the panel are installed in the speakers when the P-8AMX / P-10AMX leaves the factory.
Before turning on the mixer Before turning on the mixer
Removing The Mixer
Be sure that the mixer's power switch is turned off.
Use a screwdriver or coin to turn the screw on the mixer from LOCK to OPEN until it clicks.
Securely hold the mixer's handles to remove it from the speaker enclosure.
Use only the mixer's handles when removing the mixer from the speaker and when carrying the mixer separate from the
speaker.
CAUTIONS
NOTE:
The mixer can also be used when installed in the speaker.
When you install the mixer into the speaker, make sure to match the indentations on the speaker cabinet to the corresponding parts
on the mixer, and then turn the screw from OPEN to LOCK until it clicks.
Turning The Power On/Off
Be sure that the mixer's power switch is turned off.
Connect the included power cord to the [AC IN] jack, and plug the power
cord into a power outlet.
To avoid any loud, unexpected noise from the speakers, first turn on the
power to those connected devices that are closest to the sound source.
CAUTIONS
Example: Sound source (CD player or instrument) →P-8AMX/P-10AMX
When turning off the power to the system, reverse the order described
above.
Before turning on the power, set the LEVEL controls and MASTER
LEVEL control to their minimum setting (zero).
Press the mixer's power switch to the ON position.
To turn the power off, press the power switch to the OFF position.
4