American Standard Town Square 0780.100 Features & Dimensions

BARRIER FREE
TOWN SQUARE 27" PEDESTAL SINK
®
• American classic design
• Clean straight lines with classic ogee curves
• Rear overflow
• Supplied with mounting kit
• Design-matched to Town Square
fixture and faucets
• Right Height™ for greater comfort during use
• Made from fireclay
❏ 0780.400 Faucet holes on 4" (102mm) centers
❏
0780.800 Faucet holes on 8" (203mm) centers
❏
0780.100 Center hole only
Nominal Dimensions:
27" x 21-1/4" x 36"
(686 x 540 x 914mm)
Separate Components:
❏ 0780.004 Pedestal top 4" (102mm) centers
❏ 0780.008 Pedestal top 8" (203mm) centers
❏ 0780.001 Center hole only
❏
0031.000 Pedestal only
Bowl sizes:
15" (381mm) wide
12-1/2 (318mm) front to back
6-1/2" (165mm) deep
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.9M for Non-Vitreous Ceramic Fixtures
• CAN/CSA B45 Series
To Be Specified:
❏ Color: ❏ White ❏ Bone ❏ Linen
❏ Silver ❏ Black
❏ Town Square Faucet:
❏ Centerset Lavatory Faucet: 2555.201
❏ Widespread Lavatory Faucet: 2555.801
(shown)
❏ Other Lavatory Faucet*:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
* See faucet section for additional models available
© 2008 AS America Inc.
®
FINISHED WALL
1-3/4" DIA.
STD. DRAIN
OUTLET
3/8" (10mm) DIA.
SLAB ANCHOR
SCREW HOLES
ON 20-1/4" (514mm)
CTRS
FINISHED
FLOOR
NOTES:
* DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND "P" TRAP ARE
SUGGESTED.
▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED.
■ FOR REINFORCEMENT ONLY. TAKE ACTUAL DIMENSIONS FROM
FIXTURE.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.9M.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
J3
TOWN SQUARE
20-1/4" (514mm)
4"
(102mm)
9-5/8"
(244mm)
PED BASE PED TOP
OUTLINE OUTLINE
27"
(686mm)
SUPPLIES AS
1-1/4" O.D.
24"
*
(610mm)
22"
*
(559mm)
3/8" (10mm) DIA.
BASE ANCHOR
SCREW HOLES
ON 6" (152mm)
6"
(152mm)
®
PEDESTAL SINK
FIRECLAY
2-5/8" 4"
(67mm)
(102mm)
5/8"
(16mm)
21-1/4"
(540mm)
3-3/4" (95mm)
DRAIN
CHASE
8"
(203mm)
6"
(152mm)
REQUIRED
36"
(914mm)
WASTE
28"
1-1/4" O.D.
(711mm)
TAILPIECE
CTRS
10"
(254mm)
Revised 2/08
27"
OPEN
TO
FLOOR