Table of Contents
Advertisement
1.4.
Remove the wire screen from the air box. See
Figure 3.
1.5.
Wash screen in clean, warm, soapy water. Rinse
in clear, cool water. Air dry completely.
NOTE: It is advisable to have a supply of spare
filters and screens on hand.
1.6.
Install air filter in reverse order of disassembly.
Install engine/air filter cover. Make sure cover fits
properly. Tighten the cover retaining screws
securely.
2.
FUEL FILTER
CAUTION: Never operate your saw without a
fuel filter. The fuel filter should be replaced after
each 20 hours of use.
2.1.
Drain fuel tank completely before changing filter.
2.2.
Remove the fuel tank cap.
2.3.
Bend a piece of soft wire into a hook shape.
2.4.
Reach into fuel tank opening and hook fuel line.
Carefully pull the fuel line toward the opening
until you can reach it with your fingers.
NOTE: Do not pull the hose completely out of
tank.
Figure 3
2.5.
Lift filter out of tank. See Figure 4.
2.6.
Pull filter off with a twisting motion. Discard filter.
2.7.
Install new filter. Insert end of filter into tank
opening. Make sure filter sits in bottom corner of
tank. Use a long handle screwdriver to aid in fil-
ter placement if necessary.
3.
SPARK ARRESTER SCREEN
NOTE: A clogged spark arrester screen will dra-
matically reduce engine performance.
3.1.
Using a 10mm socket, remove the 3 bolts secur-
ing the muffler to the cylinder. Remove the muf-
fler. See Figure 5.
2
Fuel Filter
Figure 4
Bolts
Figure 5
Hide quick links:
Advertisement
Table of Contents
