Section 1: Disassembly; Rear Cover Removal; Chassis Assembly Removal; Service Position - Sony KD-30XS955 Service Manual

1-1.REAR COVER REMOVAL

3 Screws
+BVTP 4 x 16

1-2.CHASSIS ASSEMBLY REMOVAL

1
Lift lever up on the right and left sides of the chassis
bracket and gently pull the chassis assembly away from
the bezel.
KD-30XS955/34XBR960/34XS955/36XS955

SECTION 1: DISASSEMBLY

1-3.SERVICE POSITION

KD-30XS955/34XBR960/34XS955/36XS955
4 Screws
+BVTP 4 x 16
Rear Cover
5 Screws
+BVTP 4 x 16
CAUTION! - Heat sink on IC5004 is -15V. Do not allow heat sink
to touch GND or any other components.
Heat sink on Q8018 VpK=250V, is -15V. Do not touch or
short to GND or any other components.
CAUTION! - Pay attention to Neck Assembly WY Board wire
harness to BY Board. The WY Board can easily break if
there is sudden or excessive tension on the harness.
1
Lift lever up on the right and left sides of the chassis bracket
and gently pull the chassis assembly away from the bezel.
2
Pull up and rotate both the AZ and DZ Boards in order to
service the unit.
11