COLOR TELEVISION RECEIVER Chassis : KCT57A Model: CT566BVX/STR CT566BVX/XAP CT566BWX/STR CT567BWX/STR CT567BWX/XAP CT766DWX/STR CT766DWX/XAP COLOR TELEVISION RECEIVER CONTENTS Precautions Specifications and IC Data Alignment and Adjustment Tr oubleshooting Exploded View and Parts List Electric Parts List Block Diagram PCB Layout Diagram...
The current measured should the XÐray Protection Specifications Label, and not exceed 0.5 milliamp. Reverse the power- the Product Safety and X-ray Warning Note on plug prongs in the AC outlet and repeat the the service data schematic. test. Samsung Electronics...
Page 3
14. Components, parts and wiring that appear to have overheated or that are otherwise damaged should be replaced with parts that meet the original specifications. Always determine the cause of damage or overheat- ing, and correct any potential hazards. Samsung Electronics...
Page 4
Make sure that the portion around the serviced part has not been damaged. 8. Always connect a test instrumentÕs ground lead to the instrument chassis ground before connecting the positive lead; always remove the instrumentÕs ground lead last. Samsung Electronics...
Page 5
4. Do not use freon-propelled chemicals. These unpackaged replacement ESDs. Motions such can generate electrical charges that damage as brushing clothes together, or lifting a foot ESDs. from a carpeted floor can generate enough static electricity to damage an ESD. Samsung Electronics...
Page 7
VOLUME CONTROL IC STEREO MODEL ONLY IC602 TDA4053 SWITCHING IC STEREO MODEL ONLY IC701 S6709 CT633BW/CT683BW/CT766DW IC801 POWER IC STR5707 CT566BV/CT566BW/CT567BW/CT568BW KA7630 MULTI REGULATOR IC IC802 SZM322 MICOM IC901 XL24C02P EEPROM IC902 TDA9850 MTS IC STEREO MODEL ONLY ICD01 Samsung Electronics...
Page 8
RM168E (PIN 42) TDA9850 (PIN 22) TDA4053 (PIN 16) TRANSISTOR TRANSISTOR SAW-FILTER M3951M KSC2073 M9260M KSA940 2SD1887 KSC815Y 2SD1880 KSA539-Y KSD5072 E B C TRANSISTOR TRANSISTOR C2331-Y TDA8133 KSR1010 TDA8356 KA7812 KA7809 E C B Fig. 2-1 Semiconductor Base Diagrams Samsung Electronics...
Page 9
RED INPUT X-TAL (3.58) SECAM REF OUTPUT GREEN INPUT (R-Y) INPUT BLUE INPUT (B-Y) INPUT PIP/OSD RGB INSERTION SWITCH INP LUMINANCE INPUT (R-Y) OUTPUT SDIL56 (B-Y) OUTPUT LUMINANCE OUTPUT Fig. 2-2 SDIL56 CVBS : Composite Video Blanking Signal Samsung Electronics...
3. Access the Adjustment Mode by pressing the ÒVOLUMEÓ keys ( The adjustment parameters are listed in the accompanying table. Select them by pressing the CHANNEL keys ( , ). 4. After completing the Factory Mode adjustments, turn the power switch OFF. Samsung Electronics...
Page 11
STAND-BY ® MUTE ® 1 ® 8 ® 2 ® POWER ON 2. Example : Sub-bright Adjustment *FACTORY MODE* Adjustment Mpx Adjust Test Pattern Set Option Byte Factory Reset ¯ Press VOL ¯ Press CH ¯ Press VOL ¯ POWER OFF Samsung Electronics...
Page 13
FIX = “0” 1 = AUTO POWER ON 0 = MPX OPTION 1 = NO MPX 0 = NON LINEAR SHARPNESS FIX = “0” 1 = LINEAR SHARPNESS 0 = NR EXECUTE FIX = “1 “ 1 = NR SKIP Samsung Electronics...
Page 15
TV is turned on. Make sure 3. Use the specified test equipment or its equiva- that the power cord is disconnected before lent. replacing any parts. 4. Correct impedance matching is essential. 8. To protect against shock hazard, use an isola- tion transformer. Samsung Electronics...
Page 16
29.5KV under any conditions. 5. To restore picture and sound, temporarily turn off the AC power supply. After about 30 sec- SIZE 21”+ 1 25” 29” 29” + 1 onds, switch power ON. 27.5KV 29.5KV 29.5KV 29.5KV H-VOLTAGE Samsung Electronics...
Page 17
LOCATION Fig. 3-1 Tube Assembly 2 POLE PURITY ADJUST THE ANGLE (VERTICAL LINES) FIXED YOKE CLAMP SCREW 6 POLE CONVERGENCE ROTATE TWO TABS 4 POLE AT THE SAME TIME CONVERGENCE (HORIZONTAL LINES) Fig. 3-2 Purity and Convergence Magnets Samsung Electronics...
Page 18
4. Set AGC (in the Factory Mode) so that the DC level of IC TDA8375 Pin 53 is 3.0 +0.05V. 3-3-10 AFT (VCO Adjustment) 1. Input an AGC adjustment signal. 2. Select Factory Mode VCO and press the MUTE key one time. 3. GEOMATRIX adjustments Samsung Electronics...
Page 19
1. Input a lion head pattern. 2. Adjust ÒHSÓ in the Service Mode so that the left and right margins of the lion head pattern are 5.0 + 0.5 : CT633BW/CT683BW, 6.3 + 0.5 : CT566BV/CT566BW/CT567BW/ CT568BW/CT766DW 3-10 Samsung Electronics...
Open Check/Replace F801 Less than 50V More than 130V Check/Replace Check/Replace FS Check/Replace Normal AVR circuit circuit the AVR circuit. (ADJ Pin of STR) Check/Replace Check/Replace 1) D801 the power switch 2) Short the Degaussing Coil 3) C801 Samsung Electronics...
Page 21
No Raster (Sound Ok) Check that CRT Heater Check Heater plus is Lighting Abnormal Normal Abnormal Check/Replace Check/Replace Check H.V of CRT CRT Drive Circuit Check/Replace Normal Abnormal Check/Replace IC201 Check I C Data Normal Check CRT Drive Circuit Samsung Electronics...
Page 22
4-3 No Vert Scan (Horizontal Line) No Vertical Scan (Horizontal Line) Abnormal Check./Replace Check D812 (D811) Vertical Output Circuit Normal Abnormal Check IC301 Check/Replace DZ306,DZ305,R410,T444 Normal Check IC201 Abnormal Check/Replace IC201 46 47 Normal Check IC301 Abnormal Check/Replace IC301 Normal Check/Replace Samsung Electronics...
Troubleshooting 4-4 No Sound No Sound Normal Check IC603 Abnormal Abnormal Check Normal Check IC603 Speaker Normal Check IC701 Check/Replace IC603 Check/Replace IC602 Abnormal Check IC701 21 27 Normal Check IC701 Check/Replace IC701 Abnormal Check IC201 Check/Replace IC201 Samsung Electronics...
Page 24
OSD " PAL-M" or It's not normal "PAL-N" or " NTSC" signal appear? Abnormal Check B + (5V), Check ICH01 Replace ICH01 Normal Check IC901 Abnormal Check QL01, QL02 Check/Replace XL01, XL02 and X202 that part Normal Check/Replace IC201 Samsung Electronics...
DELETE MTS PART CD04 16V 47 Uf(2401-001496) DELETE MTS PART CD05 50V 1 UF(2401-000603) DELETE MTS PART CD06 p 63v 224(2305-000289) DELETE MTS PART CD13 16V 100uF(2401-001840) DELETE MTS PART CD27 P 50V 104(2306-000122)) DELETE MTS PART Samsung Electronics 6-11...
Page 40
JK206 JUMPER (3812-000219) DELETE MTS PART 03 LOT 03 LOT JKD08 JUMPER (3812-000219) DELETE MTS PART JM03 DELETE JUMPER (3812-000219) 1 CHIP PART JM04 DELETE JUMPER (3812-000219) AV SW,JACK PART JM05 DELETE JUMPER (3812-000219) AV SW,JACK PART 6-12 Samsung Electronics...
Page 41
1/8W 1 K(2001-000429) DELETE MTS PART RUD01 1/8W 8.2K-G(2004-001256) DELETE MTS PART RUD02 1/8W 160(2001-000384) DELETE MTS PART RUD03 1/8W 7.5 K(2001-000947) DELETE MTS PART RUD04 1/8W 7.5 K(2001-000947) DELETE MTS PART ZU01 CSB503 F58(2802-001054) DELETE MTS PART Samsung Electronics 6-13...