Table of Contents
Advertisement
Service Adjustments
Service Adjustment-4
FOCUS ADJUSTMENT
1. Receive the monochrome circular pattern.
2. Set the brightness to normal and contrast to maxi-
mum.
3. Adjust the focus control on the F.B.T. for the best
focus on the screen centre.
FOCUS VR (Upper side)
HIGH VOLTAGE CHECK
Note: +B (+130V) Voltage and Grayscale Adjustment must
be completed before attempting High Voltage Check.
1. Connect high voltage voltmeter negative lead to
ground, and connect + lead to anode of picture tube.
2. Tune receiver to an active channel and confirm TV is
operating properly.
3. The high voltage must be 28KV ± 1KV and less than
31.5KV at 0 beam current (Brightness and contrast
minimum setting).
Note: If the picture tube is replaced, check the high
voltage.
Protection Circuit
This TV set has a built-in power supply protection circuit.
It is provided to protect the TV set in case of a power
supply circuit malfunctions. When something abnormality
occurs during TV reception, the TV set goes to the stand-
by mode.
When an abnormality occurs during TV reception,
it causes pin 23 of the CPU to go continually Low
voltage for about one second. The CPU detects
that this has occurred and outputs the signal from
pin 36 to switch off the power supply lines.
Releasing the protective circuit and restor-
ing power supply
To release the protective circuit and restore power supply,
turn the power to the TV set OFF and then ON again via
either the main power switch or the ON-OFF button on
the remote control. This will work only if the power supply
trouble was temporary. If there is permanent trouble such
as a damaged circuit, power cannot be restored and the
circuit will have to be repaired.
-17-
-17-
Advertisement
Table of Contents
