Panasonic Lumix DMC-FS3P Service Manual page 17

Attribute Main item
HARD VENUS A/D
FLASH ROM
(EEPROM
Area)
SYSTEM
SOFT CPU
Card
CPU,
ASIC hard
Operation
Zoom
About "*" indication in the above table:
The third digit from the left is different as follows.
- In case of 0 (example: 18001000)
When the third digit from the left shows "0", this error occurred under the condition of INITIAL SETTINGS has been
completed.
It means that this error is occurred basically at user side.
- In case of 8 (example: 18801000)
When the third digit from the left shows "8", this error occurred under the condition of INITIAL SETTINGS has been
released.
(Example; Factory assembling-line before unit shipment, Service mode etc.)
It means that this error is occurred at service side.
• 6. How to returned to Normal Display:
Turn the power off and on, to exit from Error code display mode.
NOTE:
The error code can not be initialized.
Sub item Error code
High 4 bits Low 4 bits
Flash 28*0
FLASH ROM 2B*0
(EEPROM
Area)
RTC 2C*0
Reset 30*0
Card 31*0
39*0
Stop 38*0
Power on 3B*0
Zoom 3C*0
35*0
35*1
35*2
0000 Flash charging error.
IC6001-(AC17) signal line or Flash charging circuit
0001 EEPROM read error
IC6002 (FLASH ROM)
0002 EEPROM write error
IC6002 (FLASH ROM)
0001 SYSTEM IC initialize failure error
Communication between IC6001 (VENUS 4) and IC9101 (SYSTEM)
0001 NMI reset
| Non Mask-able Interrupt
0007 (30000001-30000007 are caused by factors)
0001 Card logic error
SD memory card data line or IC6001 (VENUS 4)
0002 Card physical error
SD memory card data line or IC6001 (VENUS 4)
0004 Write error
SD memory card data line or IC6001 (VENUS 4)
0005 Format error
0001 Camera task finish process time out.
Communication between Lens system and IC6001 (VENUS 4)
0002 Camera task invalid code error.
IC6001 (VENUS 4)
0100 File time out error in recording motion image
IC6001 (VENUS 4)
0200 File data send error in recording motion image
IC6001 (VENUS 4)
0300 Single or burst recording brake time out.
0000 FLASHROM processing early period of camera during movement.
0000 Inperfect zoom lens processing
Zoom lens
0000 Software error
| (0-7bit : command, 8-15bit : status)
FFFF
0000 Though record preprocessing is necessary, it is not called.
0000 Though record preprocessing is necessary, it is not completed.
17
Contents (Upper)
Check point (Lower)