Advertisement
Before You Begin
FCC Verifi cation:
NOTE: This equipment has been tested and found to comply with the limits for
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna
· Increase the separation between the equipment and the receiver
· Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
· Consult the dealer or an experienced radio/TV technician for help
IMPORTANT: Prohibition against eavesdropping.
Except for the operations of law enforcement offi cers conducted under law-
ful authority, no person shall use, either directly or indirectly, a device operated
pursuant to the provisions of this Part for the purpose of overhearing or record-
ing the private conversations of others unless such use is authorized by all of the
parties engaging in the conversation.
WARNING: Modifi cations not approved by the party responsible for compliance
could void user's authority to operate the equipment.
IMPORTANT SAFETY INSTRUCTIONS:
· Make sure product is fi xed correctly and stable if fastened in place
· Do not operate if wires and terminals are exposed
2
Tips & Troubleshooting
Troubleshooting Guide
Problem: I can't see the camera on my TV.
Solution: Ensure the camera is plugged in and the TV or VCR is tuned to the
correct input channel.
Problem: When I view my camera at night I only see a bright spot and no image.
Solution: Night Vision will refl ect when shining through a window. Move the
camera to the other side of the window or another location.
Problem: The BNC Extension Cable will not connect to my TV.
Solution: Connect the BNC to RCA adapter to the end of the Extension Cable
and plug into the TV.
Problem: On my Swann DVR, Video Loss appears where my camera should be.
Solution: Check the Extension cable is securely connected to the camera and
check the connection is secure on the back of the DVR. Also ensure the camera
has power by trying a second power outlet.
Technical Specifications
Video
Image Sensor
1/4" Color CCD
Video Quality
420 TV Lines
Number of Effective Pixels
NTSC: 510 x 492
PAL: 628 x 582
Minimum Illumination
0 Lux (IR on)
Day/Night Mode
Color during day /
switches to B&W night
White Balance
Automatic
Signal / Noise Ratio
> 50dB
Electronic Shutter
1/60 - 1/100,000 NTSC
1/50 - 1/100,000 PAL
Gain Control
Automatic
Backlight Compensation
Yes
Wide Dynamic Range
N/A
Lens
6mm
Viewing Angle
33 degrees
Night Vision
Number of Infra-Red LEDs
35
Infra-Red Wavelength
850nm
Night Vision Distance
Up to 65ft / 20m
Infra-Red LED Life
10,000 hours
General
Operating Power
DC 12V
Operating Temperature
-10°C ~ 50°C
14°F ~ 122°F
Body Construction
Aluminum
Dimensions - Camera
2.8" x 2.8" x 5.7"
70mm x 70mm x
145mm
Dimensions – Stand
2.3" x 2.3" x 4.7"
60mm x 60mm x
120mm
Weight – Camera
14.5oz / 411g
Weight – Camera & Stand
18.6oz / 527g
7
Advertisement
