JVC TH-C3 Service Manual page 26

3.3.13 Removing the lifter assembly
(See Figs.28 to 32)
• Remove the tray assemblies, DVD servo board, side (L) and
side (R) assembly.
(1) (1) From the top side of the DVD changer mechanism as-
sembly, turn the gear 1 clockwise to move the lifter assem-
bly upward. (See Figs.28 and 29.)
(2) Turn the gear 2 clockwise to move the hook toward the
front until it stops. (See Figs.28 and 29.)
(3) Move the hook stopper in the direction of the arrow 2 while
pushing the tab af of the hook stopper to unlock it in the di-
rection of the arrow 1 and release four joints ag to detach
from the rack holder. (See Fig.30.)
(4) Release the rod (L) from part ah. (See Fig.30.)
(5) Turn the gear 1 clockwise again to move the lifter assembly
upward. (See Fig.31.)
(6) Remove the lifter assembly from the DVD changer mecha-
nism assembly upward at the positions ai where the four
pins on the both sides of the lifter assembly fit to the notch-
es of the loader assembly. (See Fig.31.)
(7) Move the lifter assembly in the direction of the arrow and
release it from the hook. (See Fig.32.)
Hook stopper
Hook
Lifter assembly
Gear 1
Gear 2
Hook stopper
1-26 (No.MB358)
Gear 2
Gear 1
Fig.28
Lifter assembly
Hook
Fig.29
Hook
ag
1
ag
af
ag
Rack holder
Hook stopper
Fig.30
Lifter assembly
Gear 1
ai
Loader assembly
Fig.31
Lifter assembly
Hook
Fig.32
ah
Rod(L)
ag
2
ai ai
ai