Advertisement
RTU (Ready to Unfold) VANITY INSTALLATION
Unpack unit carefully, taking care that bottom shelf does not drop and damage front legs (see Figure 2).
Provide suitable reinforcement for anchoring the vanity to the wall. Centerline of reinforcement should be 28-1/2" up
from the floor (see Figure 1).
Rough in supply lines and waste per rough-in dimensions.
Unfold the vanity and position in desired location. The molding needs to be notched to seat the vanity flush against
the wall.
Move the vanity into place and level with the adjustable glides on the bottom of the feet.
The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible.
Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the vessel stand, located 3/4"
down from the top of the table (see Figure 2).
Anchor the vanity to the wall through at least 2 of the anchoring holes in the rear of the vanity (see Figure 2).
Continue with installation appropriate for top and sink options chosen.
FIGURE 1
FIGURE 2
C/L of 2 x 6
Reinforcement
28-1/2"
(724mm)
Finished
Floor
- 2 -
ANCHORING
HOLES IN REAR
STRINGER
(NOT SHOWN)
ADJUSTABLE
LEVELLERS
(under each foot)
7 70 0 15 - 10 0
Advertisement
