Toshiba MD24F52 Service Manual page 18

1-5: DVD MT PCB/DVD DECK (Refer to Fig. 1-5)
1. Short circuit the position shown in Fig. 1-5 using a
soldering iron. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
Remove the 4 screws 1.
2.
3. Remove the DVD Top in the direction of arrow (A).
4. Disconnect the following connectors:
(CP2301, CP2302 and CP2303).
Remove the 2 screws 2.
5.
6. Remove the DVD MT PCB in the direction of arrow (B).
Remove the 4 screws 3.
7.
8. Remove the DVD Deck in the direction of arrow (C).
1
1
2
DVD MT PCB
3
3
DVD Deck
NOTE
1. Before your operation, please read "PREPARATION OF
SERVICING".
2. Use the Lead Free solder.
3. Manual soldering conditions
• Soldering temperature: 350 ± 5˚C
• Soldering time: Within 2 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
4. When Soldering/Removing of solder, use the drawing
equipment over the Pick Up Unit to keep the Flux smoke
away from it.
5. When installing the DVD Deck, remove all the soldering on
the short circuit position after the connection of Pick Up
PCB and DVD MT PCB connector.
DISASSEMBLY INSTRUCTIONS
DVD Top
1
1
(A)
2
CP2301
CP2302
Pick Up PCB
CP2303
(B)
3
3
Short circuit using a
soldering iron.
(C)
Deck Angle
1-6: AV PCB (Refer to Fig. 1-6)
Remove the screw 1.
1.
Remove the 2 screws 2.
2.
Remove the 4 screws 3.
3.
4. Remove the Jack Shield.
5. Remove the AV PCB in the direction of arrow.
3
Fig. 1-5
B1-2
3
AV PCB
3
3
Jack Shield
Bottom Plate
1
2
2
Fig. 1-6