Specifications - Dixon ZTR 5000 Series 2000 Operator's Manual

CHASSIS:
BODY:
SEAT:
MOWER DECK:
BLADE DRIVE:
DRIVE SYSTEM:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:

SPECIFICATIONS

Model ZTR 5425
11 GA - rectangular tube
Two piece - made of rotational molded polyethylene.
contains access panels for battery service and engine to mower deck
belt removal. Rear body tilts up to allow service on the entire drive
system.
Designed for operator comfort by use of high density closed cell foam
padded back rest and arm rests, upholstered with Cordura
repellent fabric. Seat is adjustable fore and aft.
13 ga stamped steel construction. 3 blades combine for a 42" cut width.
Cut height approximately 1.5" to 4.5" via 7 position lift handle.
Electric clutch
Each rear wheel is independently driven by a HydroGear BDU-10L
Series 70 hydrostatic transmission. The hydrostatic transmissions, in
turn, power a fully enclosed HydroGear gearbox.
17HP Briggs & Stratton Intek, overhead valves, replaceable oil filter,
full pressure lube system, dual element air cleaner, integral fuel pump.
Electric by key switch operation with safety interlocks on parking brake
and blade drive clutch.
Front 11 X 4 X 5 smooth profile
Rear 18 X 9.5 X 8 Multi Trac
Front 16 - 21 lbs.
Rear 8 - 14 lbs.
Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 36
Engine - 2 qts. SAE 30 (with filter)
Width 54"
Height 45"
Length 72"
Weight 615 lbs
Additional information provided in service instructions under the
individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Front body
TM
water-
Page 13