AUPU Heater Instructions

SAVE THESE INSTRUCTIONS AND READ ALL INSTRUCTIONS
BEFORE USING THE HEATER.
Dear customers,
Thank you for selecting AUPU , which
before using the heater.
TO REDUCE THE RISK OF
PERSONS, OBSERVE THE FOLLOWING:
1. Use this heater only as described in this manual. Any other
manufacturer may cause fire, electric
the manufacture or local agent.
2. Make sure the power is off during the installation.
3.lnstallation work and electrical wiring
all applicable codes and standards.
4. For the purpose of avoiding any dangerous
be laid together with the vent-pipe of air-fueled water
5. To prevent a possible fire, do not block air intakes or exhaust
6. Do not insert or allow foreign objects
cause an electric shock or fire, or damage
7. A heater has hot and arcing or sparking parts
paint, or flammable liquids are used or stored
8. The heater must not be installed at a
9. Do not install closer than 10 inches to a
10. The heater must not be installed
11. When cutting into the wall , do not damage
12.The unit has been tested to be in
13.The heater must be properly grounded.
R.E. Williams Contractor Inc. www.rewci.com
1
Preface
is surely to bring you satisfaction. Read all
WARNINGI
FIRE, ELECTRIC SHOCK, OR INJURY TO
use not recommended
shock, or injury to persons . If you have questions,
Shut off power before servicing or cleaning.
must be done by a qualified person(s) in
gas leaking into your bathroom , the duct must not
heater into the same flue.
in any manner.
to enter any ventilation or exhaust opening as
the heat.
inside. Do not use it in area where
.
place that suffers from severe water leakage.
vertical surface and 6 feet to the ground.
beneath a fixed socket.
electrical wiring and other hidden
contact with insulation (Type IC).
14. For supply connections use
15. For overheat
ceiling exceeds 90
16. The lamps are
any part of your
17. Shut off
licensed electrician
instructions
18. Children
19. Do not use
20.To reduce risk
watts type A bulb only.
the designated
by the
contact
1. For general ventilating use only.
vapors.
2. This product is designed
ceiling or a vertical wall.
accordance with
3. To avoid
construction
4. It is highly recommended to
bathroom.
5. Please read
this may
gasoline,
PREPARATION FOR INSTALLATION
utilities.
1. Cutting a vent (Figure1)
Locate a vent position (above
at the very
No. 14 AWG or larger wires suitable
protection, exhausting automatically turns
"C (1941' ).
hot when in use. It is absolutely prohibited to touch the infrared lamps
body when in use.
power urgently when any abnormalities occur
for inspection or necessary service work.
, elders and 1 or handicapped should use this product under family
out doors.
of fire, use only type RF lamps 270 watts
affect
It may operation (even cause danger) when
one.
CAUTION
Do not use to exhaust hazardous or explosive
for installation in flat ceilings only.
motor bearing damage and noisy and/or unbalanced
dust, etc. off the unit.
make preparation for heater installation
specification label on product for further information
INSTALLATION
the ceiling) on the wall , and
position .
for at least 90 "c (194 "F ).
on when temperature above the
with
in operation. Then call your local
guidance.
maximun. Replace bulb with 60
use lamps other than
materials and
Do not mount it on a sloping
impellers, keep drywall spray,
when you retrofit your
and requirements.
then cut a 4 1/8 inches diameter hole
2