Honeywell VISIOCAM RCWL8000A Installation And Use Manual page 11

Installing the receiver
Chime tune selection
The receiver chime tune can be changed by pressing the ' ' button.
Chime tune options are as follows:
• Two note bell (Default tune for door camera)
• Saxophone (Default tune for second door camera or bell push)
• Single note bell
• Knock
The ' ' button changes the chime tune for a second door camera or a door push.
Night operation
In good daylight conditions, the receiver displays a color picture. In low lighting or at
night the display automatically switches to black and white. Infrared LEDs illuminate
the caller, so they can be viewed on the receiver even when surrounded by complete
darkness.
Low camera battery indication
When the batteries in the door camera are running low, the receiver indicates this with a
double beep warning tone that follows the chime when a visitor presses the call button.
Replace the batteries in the door camera within one week of a low battery alert.
Tamper alert tone
If someone attempts to remove the door camera by unscrewing the cover screws, the
tamper alert tone is triggered, beeping for 30 seconds. Check outside immediately.
Press any button on the front of the receiver to stop the alert tone. The alert tone is
unaffected by the chime volume switch.
Note: The alert is also triggered when you undo the cover to replace batteries in the
door camera.
MIC volume
[For future use] The topmost control along the side (see diagram on page 8) will con-
trol the volume produced from a microphone. Adjust for optimum listening level.
Scan button
When used in a multi-camera system, this button scans through available pictures.
Privacy
Remember that this product uses the public airwaves, and that the 30-second dura-
tion video signal from the door camera(s) can be picked up by nearby 2.4GHz video
receiving devices.
69-2108EFS_A.indd 9
9
VISIOCAM
69-2108EFS—01
11/30/2007 1:51:49 PM