Schlage Z-Wave User Manual

Enroll a Z-Wave
®
1. Install a fresh, high-quality battery into
the bridge.
2. Hold the bridge within 6 feet (1.8
meters) of the Z-Wave device you
want to enroll throughout the entire
enrollment process.
3. Press and release the plus (+) button
on the bridge.
4. Press the proper button(s) on the
Z-Wave device.
See the instructions that came with
the device for more information.
5. Observe the lights on the bridge. The
orange Z-Wave light will blink while
enrollment is taking place. Enrollment
is complete when the orange light
becomes solid.
See the "Lights" section for more
information on light indicators.

Exclude a Z-Wave Device

1. Install a fresh, high-quality battery into the bridge.
2. Hold the bridge within 6 feet (1.8 meters) of the Z-Wave device being excluded throughout the entire exclusion
process.
3. Press the minus (-) button on the bridge.
4. Press the proper button(s) on the Z-Wave device.
See the instructions that came with the device for more information.
5. Observe the lights on the bridge. The orange Z-Wave light will blink while exclusion is taking place. Exclusion is
complete when the orange light becomes solid.
See the "Lights" section for more information on light indicators.

Bridge Reset

1. Plug the bridge into A/C power.
2. Press and hold the plus (+) and minus (-) buttons simultaneously for 10 seconds.
3. Release both buttons.
4. The orange light on the bridge will continue to flash for 10 - 15 seconds.
This procedure can be used to initialize the bridge at any time. See "System Reset" at www.nexiahome.com
for more information.
Bridge User Guide
Device
Server Light
Z-Wave™ Light
Minus (-) Button
Plus (+) Button
A/C Input
Ethernet Lights
9V Battery Compartment
MAC ID