Panasonic RS-485 Configuration page 6

Configure the Camera - 4
• Re-configure DIP Switch 1 for the correct
unit number. See the manual for DIP
switch settings.
• Power the camera on and wait until the
self-check routine finishes.
• Note: If using Pelco-P protocol, Switch 6
& 8 (See page 13)
• If using AD Manchester protocol, swap
Switch 7 & 8 (See page 14).
Wireless and other transmission media
• It is recommended that you configure the
system wired directly to the DVR.
• Once you have the system up and
running, then proceed to introduce the
wireless, fiber, etc.
• Don't forget – any other transmission
media is just emulating a straight through
cable!!
6