Sharp KB-6024MS Service Manual page 28

KB-6025MS
KB-6025MK
KB-6025MW
7. To remove the Control Panel Frame Assembly,
remove the (5) screws holding the CP frame to the C/P
angle in the back (Fig 3).
8. Unsnap the top C/P frame assembly away from the C/P
frame and unplug all wires. The C/P frame assembly is
now free.
At this point, you will have access to all parts of the Microwave Drawer.
. Un-hook the black and white AC terminals from the Noise Filter PWB and green ground wire from the back plate.
(Fig 4).
2. Attach the black and white AC terminals from the new Power Cord to the Noise Filter as shown in figure 4.
Note: The green ground wire terminal can be attached when reassembling the back plate to the drawer cavity.
Un-hook/Attach Black AC Wire to Top Terminal
Fig. 4
Noise
Filter
Unit
Un-hook/Attach White AC Wire to Bottom Terminal
Un-hook/Attach Ground to metal Tab on Back Plate
POWER CORD REPLACEMENT
Attach White AC Wire to Bottom Terminal
Fig. 3
Back Plate
28