Subscribe to Our Youtube Channel
Summary of Contents for JW Fishers PULSE 12
- Page 1 PULSE 12 BOAT TOWED PULSE DETECTOR OPERATION MANUAL JW FISHERS MFG INC 1953 COUNTY ST. E. TAUNTON, MA 02718 USA (508) 822-7330; (800) 822-4744; FAX (508) 880-8949 Email: info@jwfishers.com WEB: www.jwfishers.com 1009...
-
Page 2: Specifications
LIMITED WARRANTY Your unit underwent constant inspection during assembly to insure many years of trouble free performance. The PULSE 12 is warranted for TWO FULL YEARS from the date of purchase. During this period, your unit will be repaired free of charge should a failure occur due to materials or workmanship. -
Page 3: Analog Output Option
ANALOG OUTPUT OPTION energy magnetic pulses (one hundred per second), from the Coil. The analog output option allows the Pulse 12 to be connected to an After each pulse is transmitted, the unit then "listens" using the Coil external device such as a strip chart recorder or data logger. The as the receiving antenna. - Page 4 Control box @ NO POSITION AVAILABLE, Fish 1=,3270,Fish 2=,1650, 150/300' cable Fish 3=,350<cr><lf> When using the Pulse 12 with a Loran C or GPS receiver the Pre-amp Coil following connection and power-up sequence must be followed for proper operation.
- Page 5 Any GPS or Loran C receiver equipped with a NMEA 0183 output mum detection envelope (a very large object). Though it is not can be used with the Pulse 12. If you are not sure if your receiver shown, the envelopes exist above the coil as well as below.
- Page 6 Figure 4b If your target is small (small anchor, motor, etc.), a slow tow speed PULSE 12 ASSEMBLY ( coil and fish ) is recommended. If the target passes too quickly below the Coil, you may get a weak reading on the meter. Experiment by passing a one gallon can past the Coil while on land.
- Page 7 ), run some tests with a metal target ( gal can is fine ) to get Sample Pulse FISH 1 FISH 2 FISH 3 the feel of the Pulse 12. There is no need to move the coil, simply Meters Speaker Zero Adj Knob move the target around, above or below the Coil.
- Page 8 • Zero Adjust Knob When the Selection switch is in Search • Batt Check Switch When depressed upward, displays condi- mode, the Zero Adjust is used to set the tion of batts on meter number 3. If batts meter to approx .1 on the scale. The Fish are ok, meter will indicate .7 to 1.
Need help?
Do you have a question about the PULSE 12 and is the answer not in the manual?
Questions and answers