Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Klutch 20244
- Page 1 ULTIMATE CAR POLISHING KIT OWNER’S MANUAL WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item# 20244...
-
Page 2: Intended Use
For technical questions please call 1-800-222-5381. INTENDED USE: The Klutch Ultimate Car Polishing Kit is used to smooth wood and metal finishes, prepare a variety Of surfaces for painting or refinishing, or polishing metal surfaces with included pad. TECHNICAL SPECIFICATIONS: Input: 120V AC, 11.0Amp... - Page 3 USE AND CARE • Do not modify the Car Polisher in any way. Unauthorized modification may impair the function and/or safety and could affect the life of the equipment. There are specific applications for which the Car Polisher was designed. •...
- Page 4 CAUTION: TO AVOID ACCIDENTAL START, CHECK TO MAKE SURE LOCK-ON BUTTON IS NOT ENGAGED PRIOR TO PLUGGING IN TOOL AND YOUR FINGER IS NOT TOUCHING THE ON/OFF SWITCH. An auxiliary handle is included with your sander/polisher to ease tool handling and to help maintain tool control during operation.
-
Page 5: Shaft Lock
OPERATION: CAUTION: ALWAYS BE SURE THE TOOL IS SWITCHED OFF AND UNPLUGGED BEFORE ASSEMBLING PARTS, MAKING ADJUSTMENTS, ASSEMBLING OR REPLACING SANDING DISCS, BUFFER PADS, OR CHECKING FUNCTION ON THE TOOL. SHAFT LOCK Never depress the shaft lock when the spindle is moving. The shaft lock is located on the top, forward portion of the gear housing. - Page 6 Hold the tool firmly using both handles. With the speed adjustment dial set at “1” turn the tool on and lightly apply the rotating foam pad to the work surface. Allow the tool to operate freely using only the tool’s weight as pressure applied to the work surface. Maintain the foam pad at an angle of about 15 degrees to the work surface.
-
Page 7: Maintenance
3) Center the sanding disc over the rubber backing pad. 4) Depress the shaft lock button located on back side of motor housing to prevent the threaded spindle from rotating. Then place the enclosed lock nut through the center hole in the sanding disc and onto threaded spindle and begin rotating the lock nut clockwise until finger tight. - Page 8 Page of 10...
- Page 9 For replacement parts and technical questions, please call 1-800-222-5381. Page of 10...
- Page 10 WARNING Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, •...