Monster Power Reference PowerSource HTPS7000 Owner's Manual page 21

STEP 11 Analog Audio AC Outlet Hookup
Isolated Monster Clean Power
sensitive analog audio components.
NOTE: Because certain components shouldn't be turned on continuously, program these outlets to "Switched On"
(see page 5, Figure 3). These components will receive power when your PowerSource
when the PowerSource is turned off.
Plug any type of low-current analog audio component (preamplifier, tape deck) into the corresponding outlet.
A) Attach a Monster
PowerSource outlet.
B) PREAMP: Plug your preamplifier's power cord into the corresponding outlet.
C) SPARE: Plug the power cord of an additional analog component into the corresponding outlet.
MANUL_HTPS_7000_Q3bn.indd Main:23 MANUL_HTPS_7000_Q3bn.indd Main:23
Stage 5 Analog Audio Filter: Optimized to provide maximum noise rejection for
™
Power ID label to each component's power cord before plugging it into the color-coded
®
Illustration of rear panel showing Analog Filter
is turned on, and lose it
™
15
4/4/06 3:08:22 PM 4/4/06 3:08:22 PM