Using The Ih19 - iHome 2go iH19 Quick Start Manual

Connecting iH19 to Power Source
a) Plug the AC adaptor cable into the  AC Adaptor Jack and the other end into a
standard 120 VAC wall socket. If an iPod is properly connected, it will begin
charging, indicated by a flashing blue  LED. The iH19 also operates on 4 "AA"
batteries (see page 4 for information on installing/replacing batteries) for portable
playing. The AC adaptor charges the iPod with or without batteries installed. The
unit will not charge your iPod while operating just on batteries.
NOTE: To save battery life, when running off Batteries, unit will automatically power
OFF after 2 hours of NON-use (no button activation). Press any button to re-activate the unit.
iPod
Playing and charging your iPod
a) Gently place iPod in iPod docking pocket behind retaining band.
b) Gently insert connector plug into bottom of your iPod. Make sure there is a power source, either batteries or AC power.
Close zipper on case. The LED on the front panel will blink if unit is off and iPod is charging. iH19 won't overcharge
your iPod. NOTE: If you dock an iPod with a drained battery, it may take up to 6 minutes of charging before the
iPod will respond.
c) Press the  iPod Play/Pause Button to play iPod, and again to pause.
d) Press   + or - buttom to increase or decrease volume.
e) Press  Forward or  Reverse buttons to go to the next or previous track. Hold  Forward or  Reverse while track
is playing to scan to a given music passage.  Forward and  Reverse do not affect components connected to the
 line-in jack.
f) Press and HOLD the  iPod Play/Pause button for 3 seconds to turn off the iPod and the unit.
Hold Switch
The iH19 has a  Hold Switch to disable button functions while on the go to prevent accidental playing of the iPod and
loss of battery power. Move  Hold Switch to ON position to lock up button functions. Move the  Hold Switch to OFF
for normal button function.
Using the Line-in and Headphone Jacks
a) An audio patch cord comes with the iH19. Use it to play nondocking iPod models or other audio devices through the
iH19  Line-in Jack (one end in the device's line out or headphones jack, the other in the iH19 line in jack). Make sure
there is no iPod connected to the iH19 when using the  line-in jack. Press the  PLAY button to mute or unmute
line-in source.
b) Use the  Headphone Jack on the iH19 to disable
the speakers and listen to your iPod privately.

Using the iH19

the speakers and listen to your iPod privately.
3
RESET
RESET
TEST
TEST