Advertisement
Quick Links
Advertisement
Summary of Contents for Smartguard AEC-931A2BS
- Page 1 User Manual AEC-931A2BS Motion Sensor Twin Light with Warning Message...
-
Page 2: Table Of Contents
Table of contents 1. Contents of package ..............Page 1 2. Smartguard™ Motion Light with Video Camera .......Page 3 3. Assembly ..................Page 3 4. Installation ..................Page 4 5. Programming your Smartguard™..........Page 7 6. Technical Specifications .............Page 8 7. General Information and Safety..........Page 9 8. - Page 3 ① ② ③ User Manual AEC-931A2BSD Motion Sensor Twin Light with Video Camera Smartguard JCD G8 bulb User Manual ④ ⑤ ⑥ ⑦ Screw D Screws Plastic Wall Mount Wire nuts Masonry plugs (Cross Bar)
-
Page 4: Smartguard™ Motion Light With Video Camera
Smartguard™ Motion Light with Video Camera overview Floodlight cover Halogen bulb PIR lens Fig. 1 Fig. 2 Step 1. Assembly 1. Install/replace the halogen bulb (see fig. 3) Make sure to unplug unit or turn off power first. Remove floodlight cover by twisting cover anticlockwise. - Page 5 Incorrect voltage may cause electric shock. If you are not sure, please contact your retailer. Note: It is recommend to mount Smartguard™ Motion Light with Video Camera 6 – 7ft above the ground for optimum performance, do not mount the fixture below 3.94ft. See below figure for details of performance range.
-
Page 6: Installation
) by screw D 3. Fix the mounting plate to crossbar (part no. 4. Connect the black wire (live wire) from the AC power cord to the single black wire coming from Smartguard using one of the supplied wire nuts (part no. - Page 7 (part no. 4. Connect the white wire from the AC power cord to the white wire coming from Smartguard using one of the supplied wire nuts (part no ⑦ 5. Connect the green/yellow wire from the AC power cord to the 2 green/yellow wires coming from Smartguard using one of the supplied wire nuts (part no.
- Page 8 Fig. 7 Please allow 1 minute warm-up time after switching on. Step 3. Adjusting the Settings (see fig. 8~9) Time control：Turn the time control knob to”+” side to increase the illumination time (7 minutes max.), turn the control knob to “－“ side Screw A to reduce the illumination time (30 seconds min.).
-
Page 9: Technical Specifications
Mode 3: Perfect for a place of business - Light at night + speaker at night - Daytime: light is off, speaker is off - Nighttime: light is on, speaker is on Audio mode: for selecting which audio message will play when motion sensor detects movement. -
Page 10: General Information And Safety
Light in a dry and cool dust-free environment or container when it is NOT used Do not open the Smartguard™ Motion Sensor Twin Light with for unauthorized service. This could cause serious damage to the unit and will void the warranty. -
Page 11: Fcc Information
FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modification to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Need help?
Do you have a question about the AEC-931A2BS and is the answer not in the manual?
Questions and answers