Time; To Manually Start Reception Of Atomic Time - Fossil ATOMIC WATCH User Manual

TIME

Your Atomic Watch will automatically update the time at
3:10am everyday, if unsuccessful it will try again at 5:10am.

To Manually Start Reception of Atomic Time

1. From Time Mode press and hold C - day-of-the-week
changes to "SEL" and flashes.
2. Press C to select receiving protocols. Corresponding icon
flashes: All -> DCF -> MSF -> WWVB -> JJY-> OFF ->.
*Your Atomic Watch will automatically try for all protocols.
If a protocol is found and there is a successful reception,
this protocol will be selected and used for the next
reception. If not, "All Protocol" will be tried on the next
reception until successful.
3. Press D (or wait 5 seconds) to confirm selection. Upon
confirmation, corresponding icon stops flashing and "SEL"
changes back to display day-of-week.
4. Radio logo and signal strength bar flash during reception.
5. Signal strength bar indicates signal power.
6. Each reception lasts for 15 minutes until successful reception.
7. Upon successful reception, time and date are updated.
7