59552A/59553A Operational Verification; Setup - Symmetricom 59552A User Manual

Chapter 3 Operational Verification

59552A/59553A Operational Verification

59552A/59553A Operational Verification
This test will require that all eight fiber-optic outputs (Ch 1 through
Ch 8) on the 59552A be tested.

Setup

1 Ensure that both the 59552A and 59553A are set to the factory default
two-signal combined operation.
Refer to Chapter 2, "Configuring Your 59552A/59553A," in this guide
for assistance in determining this operating mode. If each of the
instruments was directly received from the factory, these defaults
should already be set up.
2 Connect the equipment as shown in Figure 3-1 to begin testing of the
first fiber-output channel (Ch 1) of the 59552A.
Analog Out (IRIG)
Digital Out (1 PPS)
HP 33120A
Function Genertor/
Arbitrary Waveform Generator
HP 33120A
Function Genertor/
Arbitrary Waveform Generator
Figure 3-1. Operational Verification Setup
3-4
59553A
Fiber-Optic Receiver
(Rear Panel)
Fiber
Optic
In
Digital In
(1 PPS)
BNC Cable
Fiber-Optic
HP 54600B
Oscilloscope
59552A
Fiber-Optic Distribution Amplifier
(Rear Panel)
Ch 1
Cable
Analog In (IRIG)
BNC Cable
50Ω Feedthrough
(HP 10100C)
User's Guide