Table of Contents
Advertisement
Quick Links
GPS-207, GPS-207DC
USER MANUAL
CES WIRELESS TECHNOLOGIES, CORP.
925-122 South Semoran Boulevard
Winter Park, Florida 32792
April 17, 2012
GPS207 Manual v1p1.doc
Revision 1.1
© Copyright CES WIRELESS TECHNOLOGIES CORP. (2012)
The information contained in this document is subject to change without notice and should not be construed as a commitment by CES
WIRELESS TECHNOLOGIES CORP. unless such commitment is expressly given in a covering document.
Advertisement
Table of Contents
Summary of Contents for CES GPS-207
-
Page 1: User Manual
© Copyright CES WIRELESS TECHNOLOGIES CORP. (2012) The information contained in this document is subject to change without notice and should not be construed as a commitment by CES WIRELESS TECHNOLOGIES CORP. unless such commitment is expressly given in a covering document. -
Page 2: Regulatory Compliance
The GPRS modem was tested and certified to meet FCC Parts 15 in a stand-alone configuration, which demonstrated that it complies with Part 15 emission limits. The GPS-207 uses an Enfora manufactured GPRS modem. FCC Part 22 & Part 24 is covered by the "modular approval"... -
Page 3: Table Of Contents
1.1 About the GPS-207..........................6 1.2 About This Manual..........................6 1.3 Basic Package Contents........................6 1.4 Accessories............................6 1.5 System Requirements........................7 1.6 GPS-207 Top, Internal and Bottom View..................7 1.7 GPS-207 Activation and Deactivation....................9 2.0 Specifications............................10 2.1 System Information.........................10 2.2 GPRS Packet Data...........................10 2.3 GPS Functionality...........................10 2.4 Environment............................10... -
Page 4: Warranty
United States. Outside the US the customer must pay freight. This warranty applies to the original purchaser of the equipment only. CES Wireless is not liable under this warranty, or any implied warranty, for loss of use or for other consequential loss or damage experienced by the purchaser. -
Page 5: Change Log
Removed the old instructions. 2011-12-08 Doug Hamilton Added information about version of GPS207 that has a DC cable. 2012-04-17 Doug Hamilton Added additional information in regards to the GPS-207DC. © CES Wireless Technologies Corp – 2012 Page 5 of 17... -
Page 6: Introduction
Introduction There are two versions of the GPS-207. One (CES P/N GPS-207) is designed for monitoring the position of non-powered mobile and fixed assets. The other (CES P/N GPS-207DC) is designed for monitoring the position of sometimes-powered mobile and fixed assets. -
Page 7: System Requirements
It is necessary to have a computer running Windows 2000, Windows XP or Windows Server 2003 to program the device. The system must include a USB 2.0 port in order to configure the GPS-207. GPS-207 Top, Internal and Bottom View Figure 1: Top View of the GPS-207. -
Page 8: Figure 3: Bottom View Of The Gps-207
Figure 3: Bottom View of the GPS-207 Figure 4: Internal view of the GPS-207DC Figure 5: Top view of the GPS-207DC © CES Wireless Technologies Corp – 2012 Page 8 of 17... -
Page 9: Gps-207 Activation And Deactivation
Deactivate: Press and hold the power switch, located on the underside of the unit, for three to five seconds to deactivate the GPS-207. The LED will go solid red and then go off. When the LED is off the unit has been deactivated. -
Page 10: Specifications
-40°C to +85°C Certifications FCC: Part 15, 22 & 24 GCF: Version 3.30.1 PTCRB: Version 4.0.0 Industry Canada CE Mark RoHS Compliant SIM Card/Interface/I/O SIM Access: External GSM Antenna: Internal © CES Wireless Technologies Corp – 2012 Page 10 of 17... -
Page 11: Battery Specifications
Battery Specifications The GPS-207 uses an internal Lithium-Thionyl Chloride battery pack (CES P/N: BATTxx). The battery specifications are as follows: Cell Size Operating Temperature -40 to 85º C (-40 to 185º F) Maximum Rated Voltage 3.9VDC Capacity 4200 mAh @ 500 mA Shelf Life 10 years @ <... -
Page 12: Installation
SIM card installed. Connecting the Battery Place the battery in the GPS-207 enclosure with the label shown and with the battery cable next to the circuit board as shown below. © CES Wireless Technologies Corp – 2012 Page... -
Page 13: Choose A Location
The GPS-207 can now be closed. Replace the top cover, snap it into place and tighten the screws. Choose a location The GPS-207 should be mounted outdoors, ensuring that the top of the device has a clear view of the sky. The installer should conduct several tests in a variety of locations and situations to ensure the device has a clear view of the sky. -
Page 14: External Power Cable (Gps-207Dc Only)
Figure 9: GPS-207 Screw Holes (GPS-207 shown) Once the center points of the mounting screw holes have been marked drill the holes using the appropriate size drill bit. External Power Cable (GPS-207DC Only) The connections for the external power cable are:... -
Page 15: Battery Replacement
Battery Replacement When the battery needs to be replaced in the GPS-207 follow these steps to remove it. Section 3.2 details the steps required to insert the new battery. First, remove the GPS-207 from its installed location and open it by loosening the 4 screws. Remove the top. -
Page 16: Turning The Gps-207 On And Off
Turn off the GPS-207 To turn off the GPS-207 the button on the bottom of the device should be pressed and held for three to five seconds. The LED will go solid and then off. Once off the device is turned off. -
Page 17: Support
FILE on the DP-1000S main menu, and click on PRINT. Support Resources: www.ceswireless.com FTP Site: Please go to www.ceswireless.com and register for an FTP site User Name and Password © CES Wireless Technologies Corp – 2012 Page 17 of 17...