American Standard Robe Hook 6721 Installation Instructions

STANDARD
COLLECTION
ROBE HOOK
TOWEL RING
TISSUE PAPER HOLDER
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Recommended Tools
10'
Tape Measure
1
ROBE HOOK, TOWEL RING and TISSUE PAPER HOLDER
MOUNTING & INSTALLATION
The ROBE HOOK (1), TOWEL RING (2) and TISSUE PAPER HOLDER (3) work best if secured to a wall stud or cross brace within the wall,
using the SCREWS (3) supplied.
If the ROBE HOOK (1), TOWEL RING (2) and TISSUE PAPER HOLDER (3) is to be installed on a tile or plaster wall the TILE ANCHORS (4)
or DRYWALL ANCHORS (6) and SCREWS (3) should be used.
Determine desired height and location (optional) and mark a center line. Using the MOUNTING PLATE (5) as a template mark the two
mounting holes. If MOUNTING PLATE (5) is secured to a stud or cross brace drill small pilot holes for SCREWS (3).
For installations on drywall, use DRYWALL ANCHORS (6) and SCREWS (3) for securing MOUNTING PLATE (5) to wall. Place #2 Phillips
screwdriver or cordless screwdriver into recess of anchor. Press into drywall while turning the anchor clockwise until it is seated flush
with the wall. Place MOUNTING PLATE (5) over DRYWALL ANCHORS (6) and insert SCREWS (3) with #2 Phillips screwdriver.
See illustration below. Secure MOUNTING PLATE (5) to wall with SCREWS (3).
For installations on tiled walls, If TILE ANCHORS (4) and SCREWS (3) are used for securing MOUNTING PLATE (5), then drill
two 1/4" diameter holes a minimum of 1-1/4" deep. Insert the two TILE ANCHORS (4) flush with face of the finished wall.
Secure MOUNTING PLATE (5) to wall with SCREWS (3).
Install the WALL ESCUTCHEON (7) on the MOUNTING PLATE (5). Place the ROBE HOOK (1), TOWEL RING (2) and
TISSUE PAPER HOLDER (3) over the ESCUTCHEON (7). Secure with MOUNTING SCREW (8). Tighten fully.
Push INDEX BUTTON (9) into ROBE HOOK (1), TOWEL RING (2) and TISSUE PAPER HOLDER (3). See illustration.
4
6
5
3
6
4
Installation
Instructions
Regular Screwdriver
Drill
Phillips Screwdriver
USE MOUNTING PLATE
AS TEMPLATE
CENTER
LINE
4
30 TO 72
INCHES FROM
FLOOR
6721
6729
6723
Certified to comply with ANSI A112.18.1
U.S. Patent No. D403,750
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR
WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
3
7
3
8
5
FINISHED
WALL
2
M 9 6 8 2 1 6 C
8
9
9
8
9
1