Do you have a question about the Remote Controller and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Airwell-Fedders Remote Controller
Page 1
Room Air Conditioner This manual must be left with the owner of the equipment. Before using your remote controller, please read The information in this manual supersedes and replaces the previous instruction/operation this manual carefully and keep it for future reference.
Page 2
Contact a doctor immediately if an object is swallowed. Cooling/Heating/Fan only operation..........9. Remove batteries from remote controller if not in use for a few weeks. Otherwise batteries leakage may damage the remote Drying operation ................controller.
Page 3
2 minutes at 10 minute intervals until the room "5.0" beside the TIMER ON display of the temperature is above the set temperature, at which time the remote controller. 5 hours later 8 hours later cooling system turns back on.
Page 4
LOCK Button: When you press the LOCK button, all current To stop the air conditioner in 6 hours. settings are locked in and the remote controller does not accept 1. Press the TIMER button until the any operation except that of the LOCK. Press again to cancel...
Page 5
Therefore, keep the remote controller in a location from which it can Sleep Display transmit the signal to the indoor unit properly. Displayed by pressing the SLEEP button. The effective operation time set by remote controller is limited in 24 hours. Press the SLEEP button again to remove.
Page 6
The air conditioner will not operate if curtains, doors or other materials Stop block the signals from the remote controller to the indoor unit. Prevent any liquid from falling into the remote controller. Do not expose ON/OFF button the remote controller to direct sunlight or heat.
Page 7
* Clock accuracy is within 15 seconds per day. CAUTIONS Static electricity or other factors (in case of extremely high voltage) can cause remote controller clock initialize. If your remote controller is initialized (flashing "12:00"), readjust the clock before you start operation.
Need help?
Do you have a question about the Remote Controller and is the answer not in the manual?
Questions and answers