Weil-McLain CGa User's Information Manual page 19

User's Information Manual
Operating instructions
• Spark-ignited pilot
• Gas valve — Robertshaw 7200
FOR YOUR SAFETY READ BEFORE OPERATING
A. This appliance is equipped with an ignition device
which automatically lights the pilot.
to light the pilot by hand.
B. BEFORE OPERATING
appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle on the floor. See below.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in
your building.
1. STOP! Read the safety information above on this label.
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the appliance.
4. Remove front panel.
5. This appliance is equipped with an ignition device which
automatically lights the pilot.
by hand.
6. Depress and move selector arm left
Selector arm cannot be moved to
arm is depressed slightly. Do not force.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to
be performed.
Part Number 550-110-592/0709
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
C. Use only your hand to depress or move the selector arm. Never use
Do not
try
, smell all around the
D. Do not use this appliance if any part has been under water.
WHAT TO DO IF YOU SMELL GAS
OPERATING INSTRUCTIONS
Do not
try to light the pilot
"OFF" . Note:
to
"OFF" unless selector
TO TURN OFF GAS TO THE APPLIANCE
CGa-25 to CGa-6,
EG-30 to EG-50,
PEG-30 to PEG-50
tools. If the selector arm will not depress or move by hand, don't try to
repair it, call a qualified service technician. Force or attempted repair
may result in a fire or explosion.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control,
which has been under water.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
7. Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas,
"B" in the safety information above. If you don't smell gas,
go to the next step.
8. Move selector arm right
19. Turn on all electric power to the appliance.
10. Set thermostat to desired setting.
11. If the appliance will not operate, follow the instructions
"To Turn Off Gas To The Appliance"
technician or gas supplier.
12. Replace front panel.
3. Remove front panel.
4. Depress and move selector arm to
5. Replace front panel.
STOP!
Follow
"ON"
to .
and call your service
"OFF"
. Do not force.
550-223-044(0906)
19