Troubleshooting; Limited Warranty - NATIVE UNION MM02T Instruction Manual

6
BE CAREFUL
do not force the adaptor/jack into your mobile device, you could damage it.
We can not be held responsible for any damage you will do to your mobile device while trying to
connect your MM02T.
SWITCHING BETWEEN CONNECTED DEVICES
The line switch button is used for switching between the lines of the 2 devices connected to
the MM02T.
BUTTON UP (green ring) - correspond to the retractable 3.5mm jack with the green marking.
BUTTON DOWN - correspond to the other rectractable 3.5mm jack without the green marking.
MAKING A CALL
Once your Native Union MM02T is connected to your mobile devices, you can make a call as
you normally would. Use the line switch button to choose your preferred connection for the call.
Volume is controlled through your mobile device as usual.
ANSWERING AN INCOMING CALL
Calls on either of the connected mobile device could be answered with the MM02T. Most
mobile phone will support the MM02T button function. Just press the center button on the
handle of the handset to answer a call.
If your mobile device doesn't support the button function, you can then answer the call by
pressing the regular answer button on your mobile device.
DISCONNECTING A CALL
Simply press the center button on the handle of the MM02T to end a call. If your mobile
device doesn't support the button function, you can then end the call by pressing the regular
disconnect button on your mobile device.
REDIALING LAST NUMBER
Depending on your mobile device brand and model, you may be able to redial the last number
called by simply pressing the center button of the MM02T while the phone is in standby.
VOICE ACTIVATED DIALING
The MM02T also supports "voice activated dialing" with certain brand and model of mobile
devices. Before you can use this function, you need to set up voice tags on your mobile device
(please check your mobile device's instruction manual for more details).
To make a voice activated call, hold down the center button of the handset until you hear an
alert tone. You must then pronounce clearly the name of the contact you wish to call.

TROUBLESHOOTING

If you are having problems using your Native Union MM02T, please go to
www.nativeunion.com for further help, or consult your local retailer.
ADAPTORS
The Native Union MM02T works with most of the mobile devices available on the market.
However, some of them might require a special adaptor to connect to your MM02T 3.5mm jack.
To check which adaptor your device might need, please go to
www.nativeunion.com/adaptors

LIMITED WARRANTY

If the product appears to be damaged or does not function properly, please follow the advice
in this booklet.
If you can not find any solution in this booklet, please go to
www.nativeunion.com/support for instructions about how to obtain warranty service.